Smart Temperature & Humidity Monitor
USER MANUAL
© 2017 Tahmo, Inc, all rights reserved.
Contents and Compatibility
y
What’s Included
Tempi Tempi Base CR2032 Battery
Mobile Device Compatibility
Tempi syncs with devices that support Bluetooth 4.0.
iPhones and iPods with iOS Ver XX or later
Android Devices coming soon
Getting Started in 3 Steps
1. Install the Battery
Remove the two screws with a Philips
screwdriver.
Place the Batter
Close Tempi by aligning the top and bottom
shells using the notch
Use the screws to seal and secure the
device. NOTE: do not over tighten the
screws as it may cause damage.
2. Download and Install the Tempi App
t
Install the Tempi app by downloading it from the App Store (Google Play coming soon)
Click or tap on the icons below or search for “Tempi Bluetooth” on the App Store (Android App coming soon).
Coming Soon on Google Play
3. Connect Tempi to the App
Before connecting Tempi, make sure you activate Bluetooth on your smartphone
Launch the app and tap to Add a Tempi
App will search for a nearby Tempi(s).
Tap
available device(s) to connect
he
Name your Tempi and press Connect
Once connected, Tempi will appear on the list.
Note: If you have more than one Tempi, tap again to add add it.
App Features
t
t
Tempi’s App is full of features to help you monitor, track and control your environment.
To access the Setting Menu,
would like to set
Once in the Settings Manu, you can use
different features.
ap the Tempi you
he app’s
You will get to the main Temperature and Humidity
Screen. Tap to access the Settings Manu
Once in the Settings Manu of the app, you can use the
app’s different features.
Additional App Features
g
Rename or Delete a Tempi by swipin
left
Measurement Frequency - Adjust how often you want
Tempi to take a reading.
Note: the more frequent the readings, the more battery Tempi uses..
TempiSpecifications and Other Information
Battery
Tempi is powered by a 3 Volt CR2032 coin cell battery (included). It lasts about 4 - 9 months
depending on use. Tempi will alert you when the battery has 25% left. You can always press the
battery icon from the settings menu to check on the battery.
To change the battery, please see instructions above. We recommend using the same brand (or
one with equivalent quality), which should give you the estimated battery life.
CR2032 battery info: 3V Li-MnO2 225mAh
Operating temperature range: -22° to 140° F (-30° to 60° C)
Disposal and Recycling
Please kindly be aware that it is the consumer’s responsibility to properly dispose and recycle Tempi and
accompanying components. Do not dispose of Tempi with common household waste, the Tempi unit is considered
electronic waste and should be disposed of at your local electronic equipment collection facility.
For more information, please contact your local electronic equipment waste management authority or the retailer
where you bought the product. When discarding batteries, insulate the + and - faces of batteries with insulating or
any kind of non-conductive tape [see diagram]. If improperly disposed, lithium batteries may short, causing them to
become hot, burst or ignite.
* For complete Panasonic CR2032 battery warning and disposal information, please refer to original source:
http://industrial.panasonic.com/www-data/pdf/AAA4000/AAA4000PE15.pdf
Safety Warnings&General Precautions
- Tempi is not a toy or medical device
- Do not attempt to tamper with/modify/disassemble Tempi
- Do not expose Tempi to abrasive materials
- Do not place Tempi near open flames
Read, follow and keep this user manual and all safety instructions.
Child Safety
Tempi and its accessories contain small parts, which can be a choking hazard. Please keep away from young
children. If battery is swallowed, immediately seek medical help as serious injury may occur.
Battery Precautions
- Follow battery replacement instructions provided with this guide
- Do not charge, short, disassemble, deform or heat batteries
- Do not throw batteries into fire
- Avoid mixed use of batteries, e.g. new, used or different types
- Keep batteries away from direct sunlight, high temperature and humidity
- Keep batteries out of reach of small children. Should a child swallow a battery, consult a physician immediately
Regulatory Notices
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
INFORMATION TO USER:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by tuning the equipment off and on,
the user is encouraged to try and correct the interference by one or more of the following measures:
- -Reorient or relocate the receiving antenna
- -Increase the distance between the equipment and the receiver.
- -Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
- -Consult the dealer or an experienced radio/TV technician for help.
WARNING:
The changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC ID: 2AL87XXX
Canada: Industry Canada [IC]
IC COMPLIANCE STATEMENT:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). L‘utilisationde ce dispositif
est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) l’ utilisateur du
dispositif doit étre prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de
compromettre le fonctionnement du dispositif.
IC ID: XXXXXXX
WEEE
The symbol on the product or its packaging signifies that this product has to be disposed separately from ordinary
household wastes at its end of life. Please kindly be aware that this is your responsibility to dispose electronic
equipment at recycling centers so as to help conserve natural resources. Each country in the European Union should
have its collection centers for electrical and electronic equipment recycling.
For information about your recycling drop off point, please contact your local related electrical and electronic
equipment waste management authority or the retailer where you bought the product.
- Do not dispose of the Tempi with household waste.
- Disposal of the packaging and your Tempi should be done in accordance with local regulations.
- Batteries are not to be disposed of in municipal waste stream and require separate collection.
Need more help? Check out our
FAQs at mytempi.com/faqs
Or if you still can’t find the answer to your question, please contact: help@mytempi.com
Other ways to keep up to date and get additional support:
Follow us on Twitter @TempiSmart
Check out facebook.com/tempi.thermometer/
Loading...