1
(INEO-GW24 G2)
24 Ports 10/100/1000M
Gigabit Ethernet
Web Smart Switch
Console Port
User’s Manual
24-Port GIGABIT ETHERNET WEB SMART SWITCH
2
TABLE OF CONTENTS
CHAPTER 1 ........................................................................................ 3
CONSOLE PORT FEATURES OVERVIEW .................................................. 3
CHAPTER 2 ........................................................................................ 4
HARDWARE INSTALLATION ................................................................. 4
Accessories:.................................................................................. 4
CHAPTER 3 ........................................................................................ 5
SOFTWARE SETTING ........................................................................... 5
Open Hyper Terminal .................................................................... 5
24-Port GIGABIT ETHERNET WEB SMART SWITCH
3
Chapter 1
Console port features overview
Supports real time status (speed, duplex, link, flow
control) of each port.
Supports TX / RX / Drop / CRC / Collision counter for
statistics.
Supports port setting for enable or disable operation.
Supports port setting for N-Way or force mode
operation.
Supports Bandwidth Control on transmission and
reception.
Supports broadcast storm control.
Supports two priority queues for CoS.
Supports Port-bases / 802.1p / Diff serv. priority three
types of CoS.
Supports weighted round robin scheduling for queues.
Supports Port Mirror on TX / RX / both.
Supports IGMP snooping.
Supports Port-bases and 802.1q VLAN.
Supports network loop detection.
24-Port GIGABIT ETHERNET WEB SMART SWITCH
4
Chapter 2
Hardware installation
Accessories:
One Null model cable
One D-SUB 9 pin female connector on front panel
Fiber module (optional)-multimode/singlemode (ST or SC
type connector)
Turn off the Smart Switch powers, and then connect the
cable from PC Serial port to Smart Switch D-sub connector.
24-Port GIGABIT ETHERNET WEB SMART SWITCH
5
Chapter 3
Software Setting
Open Hyper Terminal
Follow the steps to open the program.
Step 1:
Start Programs Accessories Communications
HyperTerminal
24-Port GIGABIT ETHERNET WEB SMART SWITCH
6
Step 2:
Enter any name for new connection, and then press OK.
Step 3:
Choose serial port that you connect.
24-Port GIGABIT ETHERNET WEB SMART SWITCH
7
Step 4:
Configuration COM port properties.
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
24-Port GIGABIT ETHERNET WEB SMART SWITCH
8
Step 5:
When your console port was set OK, you will see the login
screen.
The password of factory default: admin
Step 6:
When you login were successful, you will see the main menu
screen.
24-Port GIGABIT ETHERNET WEB SMART SWITCH
9
The configuration on PC is successful. Please follow the
instruction on the screen to do all the setting.
Loading...