T3 SINGLEPASS CURL, CONVERTIBLE Series, 76577, 76581, 76580 User Manual

SINGLEPASS CURL

User Guide

1" curling Iron; 1 ¼" curling Iron
Model No. 76540, 76541, 76542, 76543, 76544, 76545, 76546,
76547, 76548, 76549, 76550, 76551, 76552, 76553, 76554, 76555,
76556, 76557, 76558, 76559

2

IMPORTANT SAFETY

INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING

When using electrical appliances, especially when children are

ENGLISH

present, basic safety precautions should always be followed,
including the following:

KEEP AWAY FROM WATER

Electricity and water are a dangerous combination and can
cause death by electric shock. Do not allow electrical cords to
come into contact with water or other liquids.

ELECTRICAL APPLIANCES ARE ELECTRICALLY LIVE WHEN

PLUGGED IN, EVEN IF TURNED OFF.

To reduce the risk of death by electric shock:

1. Always unplug the appliance immediately after using.

2. Do not use while bathing.

3. Do not place or store the appliance where it can fall or be
pulled into a bath tub or sink.

4. Do not place in or drop into water or other liquid.

5. If the appliance falls into water, unplug it immediately. Do not
reach into the water.

IMPORTANT SAFETY

INSTRUCTIONS

To reduce the risk of burns, electrocution, fire or injury to
persons:

1. An appliance should never be left unattended when plugged in.

2. Close supervision is necessary when this appliance is used
on, or near children or individuals with certain disabilities.

3. Use this appliance only for its intended use as described in
this manual. Do not use attachments not recommended by
the manufacturer.

4. Never operate this appliance if it has a damaged cord or plug,
if it is not working properly, or if it has been dropped,
damaged, or dropped into water. Return the appliance to a
service center for examination and repair.

5. Keep the cord away from heated surfaces. Do not wrap the
cord around the appliance.

6. Never use while sleeping.

7. Never drop or insert any object into any opening or hose.

8. Do not use outdoors or operate where aerosol (spray)
products are being used or where oxygen is being
administered.

9. Do not use an extension cord with this appliance.

10. This styling tool is hot when in use. Do not let eyes and bare
skin touch heated surfaces.

11. Do not place the heated styling tool directly on any surface

3

ENGLISH

4

IMPORTANT SAFETY

INSTRUCTIONS

ENGLISH

while it is hot or plugged in. Use the attached stand.

12. Before plugging in, read the information about world voltage
contained in the Operating Instructions section of this

manual.

Do not use the appliance near a bath tub, washbasin
or other vessel filled with water. Never place the
appliance in water or any other liquid.

SAVE THESE INSTRUCTIONS

MAINTENANCE INSTRUCTIONS

SINGLEPASS CURL

1. Your appliance is virtually maintenance free. It contains no
user serviceable parts and no lubrication is needed.

2. Keep heated surface clean and free of dust, dirt and
hairspray.

3. If cleaning becomes necessary, disconnect the appliance
from the power source and let it cool. Wipe the exterior with a
damp cloth.

4. If any malfunction occurs, unplug the appliance, allow it to
cool and return it to a service center for repair.

5. Allow the appliance to cool, and store it in a safe, dry location.

6. Never wrap the cord around the appliance since this will
cause the cord to wear prematurely and break. Store the cord
loosely coiled. If the cord becomes twisted, untwist it prior to
use.

7. Handle the cord carefully for longer life and do not put any
stress on the cord where it enters the handle. Avoid jerking,
twisting or straining, especially at the plug connections. This
could cause the cord to fray and possibly break.

8. Do not attempt to repair the appliance yourself.

STORAGE

When not in use, your styling tool should be disconnected and
stored in a safe, dry location, out of the reach of children. Do not
wrap the cord around the styling tool. Allow the cord to hang or
lie loose and straight at the point of entry into the styling tool.

5

ENGLISH

6

MAINTENANCE INSTRUCTIONS

SINGLEPASS CURL

SERVICING OF DOUBLE-INSULATED APPLIANCES

In a double-insulated appliance, two systems of insulation are

ENGLISH

provided instead of earthing. No earthing means is provided on
a double-insulated appliance, nor should a means for earthing
be added to the appliance.

Servicing a double-insulated appliance requires extreme care
and knowledge of the system, and should be done only by
qualified service personnel.

Replacement parts for double-insulated appliances must be
identical to the parts they replace. A double-insulated appliance
is marked with the words “DOUBLE INSULATION” or “DOUBLE
INSULATED”. The symbol (square within a square) may also be
marked on the appliance.

OPERATING INSTRUCTIONS

SINGLEPASS CURL

This appliance is intended for household use.

Use on Alternating Current (50/60 Hz).

This appliance has a polarized plug (one blade is wider than the
other). As a safety feature, this plug will fit in a polarized outlet
only one way. If the plug does not fit fully into the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. Do
not attempt to defeat this safety feature.

Do not let the heated curling barrel touch your skin as you

•

may get burnt.

• Make sure to remove the plug from the outlet after use.

• Do not use if the plug is loose in the outlet as there may be

risk of fire, electric shock, electrical shortage and burning.

7

ENGLISH

8

OPERATING INSTRUCTIONS

SINGLEPASS CURL

ENGLISH

After approximately one hour, the unit will automatically shut
itself off. To reactivate the unit, turn the Power & Temperature
switch once to the right.

This appliance contains a special electronic circuit that
automatically converts it for worldwide usage- from 100 to 240
volts AC 50/60 Hz. Just plug it into the local outlet and use it as
normal; the styler will automatically adjust to the local current.
You may need a plug adapter to accommodate the electrical
outlet of the country you are visiting.

Note: Tool heat up time may vary based on country
and voltage.

AUTO SHUTOFF

AUTO WORLD VOLTAGE

OPERATING INSTRUCTIONS

Cool Tip

SINGLEPASS CURL

9

Stand

Temperature Guide

Straight

Clip Barrel

Stand

Handle

410ºF / 210ºC
390ºF / 199ºC
350ºF / 177ºC
300ºF / 149ºC
260ºF / 127ºC

Curling Clamp

Normal to
thick hair

Fine, dama ged
or chemical ly
treated hai r

Thumb Grip

Temperature

Cord

ENGLISH

Power &

Switch

Plug

10

ENGLISH

OPERATING INSTRUCTIONS

SINGLEPASS CURL

Turn the Power & Temperature
Switch to the right once to turn

1

the tool on. Lights will cascade,
then turn solid when the unit is
ready to use.

To turn the tool off, turn the Power
& Temperature Switch to the
right and hold for 2 seconds. The
lights will cascade to the left and
turn off.

To change the temperature*, turn
the Power & Temperature Switch

2

to the right again. Continue to
turn the switch to cycle through
the temperature settings.

Release the Power & Temperature
Switch after reaching your desired

3

temperature. The selected
temperature light(s) will blink,
and lights will cascade left or right
to your selected temperature.
Wait for the lights to turn solid
before using the tool.

NOTE: Each time you turn on this styling tool, it will heat up to your
last set temperature.

* See temperature Guide inOperating Instructionsfor
recommended settings.

HOW TO USE YOUR

SINGLEPASS CURL

Always begin with dry hair. Insert
the tip of a 1-2" section of hair

1

into the clamp and roll the iron
upwards toward the scalp.

While rolling, make sure the hair
does not overlap itself around the

2

barrel. The entire section of hair
must be evenly wrapped around
the barrel.

Hold the iron until the heat has
fully penetrated the hair section.

3

Then carefully open the clamp
and release the curl.

Repeat this for the remaining
sections of hair. For a loose wavy

4

curl, tug slightly on the curled
section before allowing it to cool.

11

ENGLISH

12

T3 LIMITED WARRANTY

TERMS & CONDITIONS

T3 Micro will repair or replace (at our option) T3 products for twenty­four (24) months from the date of purchase if they are defective in

ENGLISH

workmanship or materials. This limited warranty does not cover (1)
damage due to misuse or abuse, such as incorrect voltage supply,
dropping, or failure to follow enclosed instructions or (2) tampering,
such as repair or attempt to repair. To obtain service under this
warranty, please visit t3micro.com/warrantyclaim to submit a
warranty claim, or call us at [phone] to receive detailed
instructions. You will be required to provide proof of purchase.

THIS LIMITED WARRANTY IS ONLY VALID IF THE PRODUCT IS
PURCHASED FROM AN AUTHORIZED SELLER OF T3 GOODS AND IF
THE ORIGINAL SERIAL NUMBER ON THE PRODUCT HAS NOT BEEN
REMOVED OR OTHERWISE TAMPERED WITH.

Any implied warranties, obligations, or liabilities, including but not
limited to the implied warranty of merchantability and fitness for
a particular purpose, shall be limited in duration to the 24 month
duration of this written limited warranty. Some states do not allow
a limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.

IN NO EVENT SHALL T3 BE LIABLE FOR ANY SPECIAL, INCIDENTAL,
OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY
OTHER WARRANTY, EXPRESS OR IMPLIED.

Visit www.T3micro.com/register to complete your warranty
registration.

MODEL NO.SPECIFICATIONS

76540, 76541, 76542, 76543

Operating Voltage: 100240V

Power Consumption: 6569W

76550, 76551, 76552, 76553, 76554, 76555, 76556,

76557, 76558, 76559

Operating Voltage: 100240V

Power Consumption: 65W

T3 Micro, Inc.

Venice, CA USA

Made in China

018476550D

Model: 76540, 76541, 76542, 76543, 76544, 76545, 76546, 76547,
76548, 76549, 76550, 76551, 76552, 76553, 76554, 76555, 76556,
76557, 76558, 76559
This device complies with Part 15 of the FCC Rules:
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
(2) and (2) this device must accept any interference
received, including interference that may cause
undesired operation.