T3 53886 User Manual
IMPORTANT
IMPORTANT
IMPORTANT
PROi
User Guide
Professional hair dryer
MODEL NO.
SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
When using electrical appliances, especially when children are present, basic
safety precautions should always be followed, including the following:
KEEP AWAY FROM WATER
Electricity and water are a dangerous combination and can cause death by
electric shock. Do not allow electrical cords to come into contact with water
or other liquids.
ELECTRICAL APPLIANCES ARE ELECTRICALLY LIVE WHEN
PLUGGED IN, EVEN IF TURNED OFF.
To reduce the risk of death by electric shock:
1. Always unplug the appliance immediately after using.
2. Do not use while bathing.
3. Do not place or store appliance where it can fall or be pulled into a tub
or sink.
4. Do not place in or drop into water or other liquid.
5. If appliance falls into water, unplug it immediately. Do not reach into
the water.
SAFETY INSTRUCTIONS
To reduce the risk of burns, electrocution, fire or injury to persons:
1. An appliance should never be left unattended when plugged in.
2. Close supervision is necessary when this appliance is used on, or near
children or individuals with certain disabilities.
3. Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by the manufacturer.
4. Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, or if it has been dropped, damaged, or dropped into
water. Return the appliance to a service center for examination and repair.
5. Keep the cord away from heated surfaces. Do not wrap the cord around
the appliance.
6. Never block the air openings of the appliance or place it on a soft surface,
such as a bed or couch, where the air openings may be blocked. Keep the
air openings free of lint, hair and the like.
7. Never use while sleeping.
8. Never drop or insert any object into any opening or hose.
9. Do not use outdoors or operate where aerosol (spray) products are being
used or where oxygen is being administered.
SAFETY INSTRUCTIONS
10. Do not use an extension cord with this appliance.
11. Do not direct hot air toward eyes or other heat sensitive areas.
12. Attachments may be hot during use. Allow them to cool before handling.
13. Do not place appliance, while it is operating, on any surface.
14. While using the appliance, keep hair away from the air inlets.
15. Do not operate with a voltage converter.
Do not use the appliance near a bath tub, washbasin or
other vessel filled with water. Never place the appliance
in water or any other liquid.
GROUND FAULT
CIRCUIT INTERRUPTERS
GROUND FAULT
CIRCUIT INTERRUPTERS
If you must use your hair dryer in the bathroom, install a GFCI now! Your local
electrician can help you decide which type is best for you – a portable unit
that plugs into the electrical outlet or a permanent unit installed by your
electrician. The National Electrical Code now requires GFCIs in the bathroom,
garages and outdoor outlets of all new homes.
Why do you need a GFCI?
Electricity and water don’t mix. If your hair dryer
falls into water while the dryer is plugged in, the
electric shock can kill you,
EVEN IF THE SWITCH IS “OFF”.
A regular fuse or circuit breaker won’t protect you
under these circumstances. A GFCI offers you far
greater protection.
A GFCI can save your life! Compared to that, the price is small!
Don’t wait…Install one now!
* GFCI is a sensitive device which reacts immediately to a small electric
current leak by stopping the electricity flow.
OPERATING
INSTRUCTIONS
PROi
This appliance is intended for household use.
Use on Alternate Current (60 Hertz) only.
This appliance has a polarized plug (one blade is wider than the other). As a
safety feature, this plug will fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified technician. Do not attempt to defeat this safety feature.
CHECK ALCI EVERY TIME YOU USE THIS HAIR DRYER
This hair dryer is equipped with an Appliance Leakage Circuit Interrupter
(ALCI), a safety feature that renders it inoperable under some abnormal
conditions, such as immersion in water. To make sure the ALCI is functioning
properly and the exclusive water sensing system (ALCI) is working, perform
the following test:
1. Plug in hair dryer and press test
button on plug.
2. Hair dryer will stop working. There
will be an audible click and the
reset button will pop out.
3. To reset ALCI with a Reset button:
Unplug unit. Then push Reset
button in, and reinsert plug into outlet.
RESET
TEST
OPERATING
INSTRUCTIONS
PROi
4. Be sure to repeat the test every time you use this hair dryer to confirm the
ALCI is operational.
5. If ALCI is not functioning properly, return the hair dryer to a service center.
6. If a water immersion occurs, bring this unit into a service center. Do not
try to reset.
Should the dryer go off and the Reset button pop out during use, this could
indicate a malfunction in the dryer. Remove the plug from the outlet and
allow the dryer to cool. Reset the ALCI. Reinsert the plug into the outlet.
The dryer should function normally. If not, return it to a service center for
examination and repair.
OPERATING
HOW TO
HOW TO
MAINTENANCE
INSTRUCTIONS
Main Body
Two
Concentrators
Blowout
Opening
HOW TO OPERATE
HEAT SWITCH SELECTS HEAT LEVEL
POWER SWITCH SELECTS AIR SPEED
OFF
OFF
Lock-In Cold Shot
HIGH
MEDIUM
LOW
Fast hot airflow
Soft hot airflow
Turn off
PROi
Heat Switch
Power Switch
Cord
USE YOUR
PROi
Vent
Filter Cap
OFF
Handle
Plug
Divide hair into 3-4 inch sections. Hold a section two-thirds of the
way down and pull taut.
1
Select the Power Switch to select desired heat and air speed. Aim
the dryer downward over each section until it is % dry.
2
Using a round bristle brush, brush through each section part of the
way down and hold it there very taut. Aim the dryer downward and
3
follow the brush as it pulls all the way through. To smooth the ends,
slip the brush underneath a section and blow over the curve.
Press the lock-in Cool Shot and blow cool air over the section for
a smooth finish.
4
USE YOUR
PROi
INSTRUCTIONS
PROi
MAINTAINING YOUR FILTER
The PROi is designed with a twist-off filter cap for easy maintenance. To
ensure optimum performance, twist the cap clockwise to remove it from the
rear inlet. Wipe off any dust, lint, or hair that may have collected on the filter
during use and replace the cap.
Filter Cap
LOCK-IN COLD SHOT
COOL
Press and release
for cold air
MAINTENANCE
INSTRUCTIONS
PROi
1. Make sure that the inlet and outlet grills are clear of dust and lint for
proper operating performance.
2. Your hair dryer is virtually maintenance free. No lubrication Is needed.
3. Always remove the plug from the outlet and allow the dryer to cool
before cleaning.
4. The hair dryer exterior may be wiped clean with a damp cloth.
5. CAUTION: Never allow the power supply cord to be pulled, twisted or
severely bent. Never wrap the cord tightly around the dryer. Damage will
occur at the high flex point of entry into the hair dryer, causing
it to rupture and short. Inspect the cord frequently for damage. Stop
use immediately if damage is visible, if the unit stops or if it operates
intermittently.
6. If the cord or hair dryer is damaged or does not operate properly, return it
to a service center for repair.
7. This hair dryer has no user serviceable parts. Do not attempt to repair the
appliance yourself.
STORAGE
When not in use, your hair dryer should be disconnected and stored in a safe,
dry location, out of reach of children. Do not wrap the cord around the dryer.
Allow the cord to hang or lie loose and straight at the point of entry into the
hair dryer.
T3 LIMITED WARRANTY
TERMS & CONDITIONS
PROi
T3 Micro will repair or replace (at our option) T products for forty-eight ()
months from the date of purchase if they are defective in workmanship or
materials. This limited warranty does not cover () damage due to misuse or
abuse, such as incorrect voltage supply, dropping, or failure to follow enclosed
instructions or (2) tampering, such as repair or attempt to repair. To obtain
service under this warranty, please call ... or email us at
info@Tmicro.com to obtain a Return Authorization Number as well as explicit
instructions on how to return the defective product. You will be required to
return the defective product with a proof of purchase, payment in the amount
of . (brushes/irons) or . (dryers and showerheads) to cover shipping
and handling, and a brief description of the product’s deficiencies. Please
clearly mark the Return Authorization Number on the outer package when
sending us the defective item.
THIS LIMITED WARRANTY IS ONLY VALID IF THE PRODUCT IS PURCHASED
FROM AN AUTHROIZED SELLER OF T GOODS AND IF THE ORIGINAL SERIAL
NUMBER ON THE PRODUCT HAS NOT BEEN REMOVED OR OTHERWISE
TAMPERED WITH.
Any implied warranties, obligations, or liabilites, including but not limited to
the implied warranty of merchantability and fitness for a particualr purpose,
shall be limited in duration to the month duration of this written limited
warranty. Some states do not allow a limitation on how long an implied
warranty lasts, so the above limitation may not apply to you.
IN NO EVENT SHALL T BE LIABLE FOR ANY SPECIAL, INCIDENTAL,
OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER
WARRANTY, EXPRESS OR IMPLIED.
Lock-In Cold Shot
Beautiful Outside.
Powerful Inside.
www.T3micro.com
Follow us for updates on new product
releases, stylist tips, and more.
TMICRO
Model No.
SPECIFICATIONS
Operating Voltage: V
Power Consumption: W
T Micro, Inc.
Gardena, CA USA
Made in China
Visit www.T3micro.com/register
to complete your warranty registration.
UG-53886r3
Loading...