Söll Phosphat-Test User guide

AQUA-CHECKAQUA-CHECK

www.aqua-check.de

3-

PO

4

Phosphate test

For fresh and salt water

Test preparation:

1 Fill both tubes up to the mark with the test water.

R1

3-

2 Add 9 drops of PO
(test), close with the screw top lid and mix.

3 Add the contents of the PO
test, close with screw top lid and mix.

R1 to one of the two tubes

4

3-

R2 ampule to the

4

Measure after exactly 5 minutes

reaction time.

Measuring with AQUA-CHECK:

1 Reference measurement.

2 Test measurement.

You will nd important information on your measurement value at www.aqua-check.de.
Please observe the safety notes for handling chemicals (see rear).

9 x

R2

5 min.

Immediate

Corrosive

3-

4

Phosphate testPO

Version 1.0 • 03/2012

3-

PO

R1 (phosphate test)

4

R35: Causes severe burns.
S1/2: Keep locked up and out of the reach of children.
S26: In case of contact with eyes, rinse immediately with plenty of

water and seek medical advice.
S30: Never add water to this product.
S45: In case of accident or if you feel unwell, seek medical advice

immediately (show the label where possible).

Contains sulphuric acid

3-

PO

R2 (phosphate test)

4

S2: Keep out of the reach of children.
S46: If swallowed, seek medical advice immediately and show this

container or label.

Contains tin chloride.

May cause allergic reactions.

Take packaging with product residues to hazardous or special waste disposal.

Söll GmbH • Fuhrmannstraße 6 • D-95030 Hof • www.soelltec.de • Tel. [phone]

Söll hotline: [phone] (14 cents/minute from a German landline)

CLHM2-16002