High-Precision Microwave Radar
User Guide
V1.0 2017.1
Introduction
High-Precision Microwave Radar can be mounted onto any side of the carrier for
distance and angle measurement.
Mode Switching Button
Data/Power Port
Radar Status Indicator
Mounting Holes (M3)
Multifunction Port (Reserved)
Warning
1. Ensure that the radar module is working within its detection range.
2. Observe the carrier’s distance from the surface at all times.
3. Operate with extra caution when flying over inclined surfaces.
4. Obey local radio transmission laws and regulations.
Installation
1. Mount the radar module to the carrier using M3 screws.
2. Connect the radar data cable to a control unit which has data processing functions.
Connect the radar power cable to the power supply (direct-current voltage 12 to 20 V).
Mode Switch
The radar should work in a corresponding operating mode when it is mounted onto
different sides of the carrier. The operating mode must be set correctly through the
Mode Switching Button on the module.
Instructions: Ensure that the radar module is powered off. Press the Mode Switching
Button and hold, and then power on the module (the button cannot be released at this
moment). A white light after blinking several seconds from the Radar Status Indicator
means that it is in mode switch process and you can release the button. Press it the
button to switch the operating mode. The operating mode is displayed by the Radar
Status Indicator:
Loading...