SZ DJI TECHNOLOGY CS7851702 Users manual

CrystalSky User Guide

CS785/CS785U/CS550

Disclaimer

Congratulations on purchasing your new DJITM product. The information in this document affects your safety and

your legal rights and responsibilities. Read this entire document carefully to ensure proper configuration before

use. Failure to read and follow instructions and warnings in this document may result in serious injury to yourself

or others, damage to your DJI product, or damage to other objects in the vicinity. This document and all other

collateral documents are subject to change at the sole discretion of DJI. For up-to-date product information, visit

http://www.dji.com and click on the product page for this product.

By using this product, you hereby signify that you have read this disclaimer and warning carefully and that you

understand and agree to abide by the terms and conditions herein. You agree that you are solely responsible for

your own conduct while using this product, and for any consequences thereof. You agree to use this product only

for purposes that are proper and in accordance with all applicable laws, rules, and regulations, and all terms,

precautions, practices, policies and guidelines DJI has made and may make available. DJI accepts no liability for

damage, injury or any legal responsibility incurred directly or indirectly from the use of this product. The user

shall observe safe and lawful practices including, but not limited to, those set forth in this document.

DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as DJI) and its affiliated companies. Names

of products, brands, etc., appearing in this document are trademarks or registered trademarks of their respective

owner companies.

Warnings

1. Ensure to press the Battery Remove Button before remove the battery.

2. DO NOT attempt to touch the metal terminals on the Power Adapter.

3. Clean the metal terminals with a dry, clean cloth if there is any noticeable buildup of dirt.

Introduction

CrystalSky is a designed specifically for aerial photography that can display clear image under bright light. Use

built-in DJI GO App / DJI GO 4 App to control the gimbal, camera and other features of your flight system. The app

also comes with Map, Store a User Center, for configuring your aircraft and sharing your content with friends.

In the Box

CrystalSky Display Screen × 1

Battery ×2

Charging Hub × 1

SD Card Mounting × 1

Mounting Bracket × 1

Hood × 1

Insulation × 1

Extended Module (Optional) × 1

CS785/CS785U

CS550

Parts

1. HDMI Port

Output HDMI video signal.

2. USB Port

Supported extended device, e.g. U disk.

3/4. Micro SD Card Slot

Provide extra storage space for the display device, maximum supporting 128 GB.

5. Micro USB Port

Configure parameters and upgrade the aircraft by connecting to the DJI Assistant 2 using the USB OTG cable.

6. Headphone jack

7. Light-sensitive Port

Built-in light-sensitive sensor.

8. Type C USB2.0 HS Port

9. Built-in GPS

10. Power Button

11. Custom Button

12. Setting Button

13. Custom Button

14. Playback Button

15. Battery Remove Button

16. Battery Slot

*Use the CrystalSky CS785 for installation illustration.

Usage

Low

High

Charging the Battery

Checking the Battery Level

Press the Battery Level Button once to check the battery level, and press again to power off.

Charging

Install the battery into the standard charging hub, and connect the plug the connector B of the battery

charger to the charging hub, then connect the battery charger to a power outlet (100-240V, 50/60Hz).

.

Tips: The charging hub can charge two batteries at the same time. It will take a longer time to charge the Intelligent Flight

Battery and remote controller together.

Mounting the Battery

Put the battery into the Battery Slot, then push it to the end until you hear a click.

Note: Ensure to press the Battery Remove Button before remove the battery.