Sytech SY-TS20 Instruction Manual

Bread Toaster

SY-TS20

Instructions Manual

Welcome

Thank you for your purchasing the SY-TS20 Toaster. Before using the appliance, please read
these instructions carefully and store them in a safe place for future reference.

Specifications

Important safeguards

 This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.

 Children should be supervised to ensure that they do not play with the appliance.
 Before using, ensure the voltage of your power supply is the same as that indicated in the

instruction manual, only connect appliance to alternating current to a correctly installed
earthed socket, cord and plug must be completely dry.

 Do not leave the appliance unattended during use.
 Do not pull the connection cord over sharp edges; keep the cord away from heat and oil for

protection.

 Do not place the appliance on hot surfaces or near it.
 Do not pull the plug out by the cord or pull it out of the socket with wet hands.
 During use children are not allowed to touch the appliance to avoid danger.
 If the following happens, please unplug the appliance to disconnect the power supply.

--The appliance or cord has been damaged.

--The appliance has been dropped accidentally or any malfunction is detected.

 Before switching on, ensure the slices of bread do not get jammed in the toaster slots.

However, if this happens, unplug the appliance first and then take out the jammed bread
slice.

 Caution: In the event of burning the bread, the appliance may become too hot. Never

touch the toaster at this time.

 Note the housing of the toaster will become very hot when using, especially in the area of

the toaster slots. Please be careful not get burnt. Please only use the control knob, lever
and button to operate.

 Do not insert your fingers or metal objects like knives or forks into the bread slots.
 Only use the appliance when it is horizontally placed on a suitable surface.
 Do not toast the bread with wrapped aluminum foil.
 Do not cover the bread slots while in operation.
 Never put bread slices or bread roll into the bread slots directly, as this may cause

overheating.

 Unplug the appliance before cleaning and maintaining.
 Do not immerse the appliance into water or other liquid.
 Your appliance must never be switched on through an external timer or any kind of

separate remote control system.

 Improper use or repair may cause a risk of danger. In case of misuse or incorrect handling

or repair, no liability will be taken for possible damages.

 The appliance is only designed for indoors using, not for outdoors using.
 Should the cord be damaged, to avoid danger, it should be replaced by the qualified

technician of service agency or its authorized service agency.

 Do not put the appliance on or near the gas cooker, electro thermal elements or hot plate

as well as other electric appliances.

 Keep the appliance away from wall, curtain and other combustible material during use.
 Don't place anything on the appliance besides baking bread.
 Don’t use the appliance without bread for a long time.
 Use the appliance for domestic purposes only and in the way indicated in these

instructions.

 Never use the appliance outside and always place it in a dry environment.
 Never immerse the appliance in water or any other liquid for any reason whatsoever. Never

place it into the dishwasher.

 Stand the appliance on a table or flat surface.

Instructions for Use

General description

1) Push Button

It is used for toasting round bread

2) Defrost Button

After pressing the button, the appliance will defreeze the frozen bread
automatically. It will take about 30 seconds. At the same time, the thawing
indicator light is on.

3) Reheat button

After pressing the button, the appliance will reheat the bread. If the setting for
the bread browning degree is found too light the button can be pressed for
reheating. At this time, the reheat indicator light is on.

4) Rotary Button

It is used to control the time

5) Cancel button

It is used to cancel the toasting process at any time

6) Crumb tray

It is used for collecting crumbs. You can slide out the tray and clean up the
crumbs.

Selecting the browning level

Grades

Bread type

1-3

Thin bread slice

3-5

General bread

5-6

Frozen bread

How to use the appliance

Set the control knob to the suitable position, put the bread slice into the toast slots
(there should be a minimum space of approximately 15mm between the slot and the
bread, otherwise, the slice will get stuck.) and press down the lever, then the toaster
begins to toast. As soon as the toasting cycle is completed the slices of bread will
automatically be ejected.

Suggestion:
Before using the toaster for the first time, it is suggested to operate it without
any bread inside and with the control knob set to grade 3 and the lever in down
position to remove the heating element protection finish. At this time, the
appliance will begin to emit smoke. This is normal. It is recommended to have

a good ventilation of air. After the first heating, let it cool down naturally before
being used again.

Cleaning

 Before cleaning, switch off and unplug the appliance and have it cool down.
 Remove the crumbs from the browning slots and grids with the appliance not

tilted. Then, open the door, clean away the crumbs and put the door back to the
appliance.

 Clean away crumbs from toaster.
 Remove the crumbs from the browning slots and grids with the appliance not

tilted. Then, slide out the tray, clean it and put it again into the appliance.

Outside cleaning:

Clean the outside of the appliance gently with a damp and soft cloth, and then
wipe it with a dry cloth. Never use steel wire, abrasive cloth or other caustic
cleaning agents, as they will damage the finish of the appliance.

Maintenance

 It is not allowed to dismantle the appliance or change its cord by you. If there is

any trouble with the appliance, please have it adjusted or repaired by service
agency.

 During use, if any defect of the appliance is suspected, please take it to service

agency or its authorized service agency. They will check for customers without
charge if the appliance can be used safely or not.

DECLARATION OF CONFORMITY

Manufacturer Name: Satyatrade S. L.
Address: Pol. Ind. La Raya. C/ Guadalquivir, 2.
Camarma de Esteruelas, 28816 Madrid
Tel: [phone]
Fax: [phone]
NIF: B83254763
Manufacturing country: China
Sytech® SY-TS20 complies with the following directives:

EMC Standard: Directive 2004/108EC
EN 55014-1:2006+A1
EN 55014-2:1997+A1:2001+A2:2008
EN 61000-3-2:2006+A1+A2
EN 61000-3-3:2008

LVD standard: Directive 2006/95/EC
EN 60335-2-9:2003+A1:2004+A2:2006+A12:2007
EN 60335-1:2002+A1:2004+A11:2004+A12:2006+A2:2006+A13
EN 62233:2008

ROHS standard:2002/95/EC Restriction of Hazardous Substance

Signed: Ajeet Nebhwani Utamchandani
Sole Administrator