SYStronics TIC-4M User Manual

TIC-4M MANUAL

1

1404, 301, Bucheon Techno park, 345, Seokcheon-ro, Bucheon-si, Gyeonggi-do, Republic of Korea

Phone : [phone] Fax : [phone] Homepage : www.ss22.com

TIC-4M

USER MANUAL

Compact Temperature Controller

VER 1.0SYStronics. Co. ltd.,

TIC-4M MANUAL

2

Be sure to read and ensure that your safety precautions are used to protect your safety and prevent property
damage. We shall not accept any liability for any loss caused by the use or carelessness caused by the use
or handling of this manual.

Warning

If this product is not intended as a safety device, use a double safety device for fear of accidents, damage of
critical peripheral equipment, and equipment that is feared to cause extensive property damage.

Safety instructions

1. Be sure to check the equipment after disconnecting mains.

2. Do not disassemble and repair this product ; it is not possible to manufacture any product.

3. Do not spray water directly or clean it with benzene, jazzy, or alcohol.

Notes on the Environment

Do not install this product in the following locations and environments :

1. Places directly exposed to mechanical vibration or shock

2. Places exposed to corrosive gases or combustible gases

3. Position directly exposed directly to direct sunlight

4. Places affected by electromagnetic waves

5. Places where high temperature or humidity is high (sites with over 85 % of ambient humidity)

6. Places where dust and salt are plentiful

Precautions on installation

1. Make sure that the installation work is related to the installation or qualified personnel only.

2. Do not place any device or wiring that caused noise (NOISE) near the product.

3. Avoid near heating apparatus.

4. Disconnect all appliances (OFF) after disconnecting them from the wiring.

5. Do not work with wet hands. Risk of electric shock.

6. Install and use the method described in the User Manual as instructed in the Instructions for Use.

7. Do not turn on (power on) prior to the connection between the unit of manufacture of this unit.

8. Do not use any load exceeding the opening and closing capacity of the output contacts.

Immunity condition

1. In addition to the contents set forth herein, no warranties and responsibilities shall be made regarding this
product.

2. Whether or not this product is likely to be unforeseen defects and natural disasters due to the use of this
product, the user or the third person We shall not be held liable for any indirect damage.

Precautions

TIC-4M MANUAL

3

Product Overview

The TIC-4M Temperature Controller is a dedicated controller for cooling, refrigerating, cooling,

and heating operation, It is possible to use up to 4 ports of output and 1 ports of temperature

sensing port. You can also change the temperature monitoring port to input 2 ports by setting the

temperature monitoring port according to the setting conditions, and customize it to suit the site conditions. This
is a product that is equipped with a built-in communication 1port (up to 2 ports), which enables remote
monitoring and control.

·User setting function for various field conditions

· Digital Input 2 Port / Digital Output 4 Port

· RS-232 communication 1 port / NTC temperature monitoring port 3 port

· Application of coolers, heaters, units coolers, Showcase, etc.

TIC-4M MANUAL

4

Product Component

Controller

(1EA / TIC-4M)

Bracket

(2EA)

Normal type

NTC sensor

(1EA / SCTS-01)

Sensor Component

Advanced NTC

sensor

(1EA / SCTS-02)

High temperature

type NTC sensor

(1EA / SCTS-03)

Well type NTC

sensor

(1EA / SCTS-04)

(Choose one of the four sensor)

TIC-4M MANUAL

5

Product Specifications

Controller Specifications

Input Power 220VAC, 50/60Hz

Output Voltage 220VAC, 50/60Hz

Output Capacity 250VAC, 5A (Relay output)

Output Port 4 Port (Input power output)

Input Port 2 Port (Non-power source) / Changeable to temperature sensor input

Sensor Port 1 Port (NTC : 10K at 25℃ ±1℃)

Communication Port 1 Port (RS-485)

Operation Temperature -10 ~ 60℃ (Non condensation)

Operation Humidity 5 ~ 90% (Non condensation)

Storage Temperature -20 ~ 60℃ (Non condensation)

Controller Weight 282g

TIC-4M MANUAL

6

Sensor Specifications

Normal type cable sensor (SCTS-01)

Temperature Range -45 ~ 80℃ (NTC : 10K at 25℃ ±1%)

Sensor Weight 58g (Cable 3M standard)

Advanced type cable sensor (SCTS-02)

Temperature Range -45 ~ 105℃ (NTC : 10K at 25℃ ±0.5℃)

Sensor Weight 37.5g (Cable 3M standard)

High temperature type cable sensor (SCTS-03)

Temperature Range -45 ~ 150℃ (NTC : 10K at 25℃ ±1%)

Sensor Weight 64.5g (Cable 3M standard)

Well type cable sensor (SCTS-04)

Temperature Range -45 ~ 80℃ (NTC : 10K at 25℃ ±1%)

Sensor Weight 84g (Cable 3M standard)

TIC-4M MANUAL

7

Front view

Product Dimension

Top view

Side view

Front view Side view

Bracket Dimension

Controller Dimension

Display

42.5 x 20.3