2.4G Wireless Mouse Users’ Guide
Installation
1. Plug the receiver into a USB port on your computer.
2. Insert battery into the mouse.
3. This mouse provides factory default ID and so the link will be set up after a while.
4. Click the mouse key and her response will be read on the monitor.
Trouble Shooting
1. No connection between the mouse and the receiver.
Re-insert the receiver. Try to insert receiver to another USB port on your computer.
2. No any response on the mouse.
Take out the battery from the mouse and reinstall it with correct orientation. Try a
new battery if necessary.
Note:
FCC statement:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on. The
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to computer
or peripheral devices).
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of FCC RF Rules. Operation
is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause
undesired operation of the device
Caution!
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user authority to operate the equipment.
Declaration of Conformity
Hereby, Sysgration Ltd, declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
Loading...