Syrp Genie II pan tilt Setup Manual

II pan tilt

Setup Guide

Welcome to the Syrp family

Before you start filming, there are a few simple steps

to follow to ensure your Genie II is assembled

correct and you’re shooting smoothly.

This guide will walk you through the correct Genie II

set up, as well as some helpful tips.

Additional resources can be found at

support.syrp.co.nz

QR Camera Plate 65mm

What’s in the Box

Genie II Pan Tilt (Battery incl.)

USB-C Charge Cable

1/4" - 3/8" Adapter

Charger

USB-C to Shutter Release Cable

AU/NZ Plug

Euro PlugUSB Adapter

UK Plug

USA Plug

Genie II Pan Tilt

Quick Release Button

LCD Display

Back Button

Rotation Lock

Camera recording light

Charging light

Wireless connection light

USB-C Ports x3

Pan Tilt Base 90mm

Power Button

Joystick

Quick Release Lock

Battery Cover Catch

Quick Release

Camera Plate

3

UNLOCK

Open the Quick

Release Lock

2

1

Remove the rubber
stopper to swap
between 1/4” & 3/8”
Camera Screws.

SWAP

Mount Camera

!

IMPORTANT
Ensure the Quick

Release Camera

Plate is locked once
the plate is installed

3

1

2

Mount the Genie

Genie II Linear

Remove the Quick Release
Plate from Linear. Push the
Pan Tilt down into the Linear
and lock the Quick Release.

2

1

Standard Tripod

Screw the Pan Tilt clock wise
onto a 3/8 thread and fully
tighten.

Use the Rotation
Lock to achieve
sufficient tightness

3

LOCK

Ensure the Genie Pan
Tilt is locked in place
once installed.

Mounting Warning

You must ensure the Quick Releases are installed correctly.

7

Incorrect installation could result in your equipment
detaching and cause harm to your equipment or others.

!

IMPORTANT
Insure the Genie Quick
Release base is fully
inserted. It should be flush.

WARNING

!

Always ensure the Quick
Release base is not
partially inserted.

Remove / Install Battery

Before you use the Genie
for the first time you must
remove the battery tape

2

UNLOCK

Lift up the Battery

Cover Catch

1

3