SynerTech ST 2326 User Manual

ST2265 / ST2326

315MHz Wireless Remote Electrical Control

Installation and operation manual

Introduction

Thank you for purchasing this SynerTech product.
This surveillance set is an easy-to-use and DIY installed Wireless Door Chime.
To obtain the best performance from this product, please read through this manual carefully. It will
guide you to operate a full set of 315MHz 315MHz Wireless Remote Electrical Control

Feature:

z 315MHz ISM Band
z With 30 meter Operation range in open field
z 1 Unit of 12VDC 23A battery for hand held remote control
z Extended a 30 cm length of US plug with earth Power Cord
z ST2265 for double US socket outlets with earth
z ST2326 for single US socket outlet with earth
z Total rating 13A for outlet(s)

z Comply with UL and FCC

1

Operation Guide

Hand Held Remote Control

 For battery replacement and installation on wall, back cover has to be removed.
 For the battery replacement, check the polarity of 12V 23A battery and insert into correct connection plate.
 There is key chain hole for user , if applicable.
 There are two button for control and LED for indication.
 CONCAVE shape button for OFF function.
 CONVEX shape button for ON function.
 When either button pressed, LED is flash as indication of wireless transmission.

Receiver Unit

 Plug the extended power cord plug into desired wall socket.
 Then it is ready to receive the control signal form Hand Held Remote Control.
 Press “ON” button on Hand Held Remote Control, there is electricity in socket outlet.
 Press “OFF” button on Hand Held Remote Control, the electricity in socket outlet is OFF.
 For temporary mounting on wall, there is a hanger hole on the back of unit.
 The MAX. operation range is about 30 meter (line of sight)

Operation Precautions :

 DO NOT drop or shake the unit or subject the unit to shock.
 DO NOT clean the unit with benzene, thinners, or any solvents. Wipe off dust and marks with a soft cloth

which is slightly moistened in mild soapy water.

Installation Precautions :

Before installing this product, please bear in mind of the following:

 DO NOT position the units where they will be subjected to extreme moisture, temperature, rust or dust.
 DO NOT install the Receiver Unit to where it will be exposed to direct sunlight, rain or extreme moisture. A

closed-in porch or sheltered area is an ideal location.

 DO NOT install near to other electronic equip ment.
 DO NOT overload the socket outlet.
 DO NOT install near the source of acid oxides, ammonia, or any harmful gas.
 Keep away from children access.

Warning :

-To prevent injury, this apparatus must be securely attached to the wall in accordance with the installation
instructions.

-Under the environment with radio frequency interference, the sample may malfunction and require user to
reset the sample.

2