
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
INSTALLATION INSTRUCTIONS
SYNERGY SUSPENSION
PPM-8088 JK REAR SHOCK RESERVOIR
MOUNT
GENERAL NOTES:
• These instructions are also available on our website at www.synergymfg.com.
Check the website for any updated instructions and additional photos for
reference.
• Installation of this bracket can be done with simple hand tools and a power drill of
some kind.
PARTS LIST:
• 1 - PPM-8088 JK Rear Resi Mount
• 4 - 3/8-16 UNC 1” bolt
• 4 - 3/8-16 UNC flange nut
• 4 - 3/8” flat washers
INSTALLATION:
1) Installation can be done with vehicle on the ground.
2) First, fit up the 8088 Rear Resi Mount as pictured below. Position it on the crossmember which the shock mounts tie into. Center the mount on the cross-member.

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
3) Mark and drill out four 3/8” holes in the cross-member.
4) Bolt up the 8088 Resi Mount with the 3/8-16 UNC bolts provided in the kit. Use a
flat washer under the head of the bolt. Utilize the flange nuts on the inside of the
cross-member. Torque bolts to 35 ft-lbs.
5) Secure reservoirs to the cross member as shown. Be sure to mount reservoirs in a
way that does not kink the hoses. Installation is now complete.

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397