Synergy 5804 User Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA [phone]

PPM-5804 TJ FRONT GRAB HANDLE KIT

Version 1.0

GENERAL NOTES:

• Read installation instructions fully prior to beginning installation.

• Check our website at www.polyperformance.com for updated instructions.

• It is necessary when installing the grab handles to remove the front hard top

section or to fold back the front soft top section.

• The grab handle kit is a bolt on installation but you do have to trim some of

plastic interior trim and roll cage padding. A dremel type tool or straight air
grinder with a small drum sander works well for this.

Complete PPM-5804 TJ Front Grab Handle Kit

1) Remove A-pillar windshield trim if vehicle is equipped with it by first removing the
sun visor.

a. Next, remove upper side window frames by unscrewing top dial fasteners.
b. Remove the outer torx head bolt (T-40) which connects the B-pillar to a-

pillar. This is your forward attachment point for the grab handles.

c. Unscrew the three Phillips head screws that run down the length of the a-

pillar trim.
d. Remove the sun visors. There is one screw holding them in.
e. Trim should be loose at this time, to fully remove, locate plastic barb

fastener at top of trim and pry free. Pull the trim away from the windshield

as there is a small clip by the sun visor attachment which holds it in place.

(See pictures below)

Plastic barb fastener at top of A-pillar trim