
Wireless Access Point
Quick Start Guide
Step 1: Package Contents
Unbox and verify the following contents:
Wireless Access Point
•
• Auxiliary tool for installation
• Wireless Access Point Quick Installation Guide
• 1 RJ45 Ethernet Cable
Step 2: Hardware Installation
• Power on your computer
•
Connect one end of ethernet cable to POE switch port and the other end to
Wireless Access Point
• Ensure that the Power LED is on (LED will glow in Green)
• Ensure that the Wireless LED is on (LED will glow in Green)
’s WAN port and power on the AP

Step 3: Access Point Configuration
• Connect one end of the RJ45 Ethernet cable to the POE switch and other end to the
Ethernet port of the computer
• Ensure that the Network Connection is enabled on your computer
Assign an IP address within the range (192.168.1.2-1.252) e.g. 192.168.1.10 to
•
your computer
• Management IP for the AP is 192.168.1.253
To configure the AP, open a web browser in your computer and type the following
•
URL. http://192.168.1.253
• A login screen will appear. By default, the username of the AP is admin and password
is pronto. You can set desired password after logging into the AP
• Configure the AP, as you desire
By default the AP will broadcast unsecured ESSID as Synectix. The AP has
•
provision to setup 4 ESSIDs and also to setup security for each one of them.
• Connect Internet back-haul to POE switch
•
Connect your computer to default Synectix ESSID and access Internet
• Congratulations !! Your AP is configured successfully... Enjoy surfing Internet on Wi-Fi
SYNECTIX, LLC
291-A PEPES FARM ROAD MILFORD CT 06460 USA

. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance
could void the user's authority to operate the equipment.