Page 1
Zebra sheer shade
Thank your for purchasing this product. Please read the instructions and warnings carefully before use to
ensure safe and satisfactory operation of this product. It is recommended that this blind should only be
installed by persons competent in DIY.
Please check the contents
Please note : Additional fasteners other than those sent
with your blind may be required depending on
the mounting surface.
Wallboard and plaster require the use of anchors such
as expansion or toggle bolts.
Brick, tile or stone need special plugs and drill bits.
Remember to always pre-drill holes in wood to
avoid splitting.
1. Positioning the blind
1-1. Inside mount
Decide the position of the blind so that it will be clear of any latches
and xtures. If you need to reduce the width of the blind to t the
recess, this should be done before assembling.
See instructions for reducing the width below.
1-2. Outside mount
Decide the position of the blind so that the overlaps on both sides are
equal. It is advisable to allow a minimum of 5cm overlap on each side.
Page 2
2. Installing the headrail
g. 1
2-1. Fit the headrail using the brackets provided.
2-2. When tting to plaster, uses the plastic wall plugs provided.
2-3. Brackets should be installed no greater than 1.5 cm from each
end with intermediate brackets spaced evenly. (g.1)
3. Top xing
Simply screw the spring dips directly to the wall under
the window frame. (g. 2)
max.15cm
max.15cm
5cm
m
5c
4. Face xing
Attach the spring clips to the L shaped brackets with the small
nuts and bolts as shown, then x to the wall on frame. (g. 3)
5. Fitting the blind
5-1. Position the top of the headrail against the spring clips and click into place.
5-2. Please note, to remove for cleaning, etc. gently prise away the headrail from
the clips using a screwdriver. (g. 4)
①
②
Page 3
6. Notice
For better stability, it is
better to put the transparent
Mechanism can be
installed on either side.
hand holder in the middle
of the bottom rail.
7. Care and maintenance
The fabric may be dusted using a dry cloth. To clean, wipe with a damp cloth. Please ensure blind does not
become wet to avoid water damage.
Loading...