Page 1
INSTALLATION INSTRUCTIONS FOR ONE-WAY / SINGLE TRAVERSE ROD (Drop In)
PARTS LIST
Fig. 1
2
1. Pulley Housing
2. End Bracket
1
3. Inside Section of Rod
4. Outside Section of Rod
5
4
3
7
6
8
ONE WAY-CORD LEFT ONE WAY-CORD RIGHT
5. Center Support
6. Cord
5
7. Slide
8. Master Carrier
3
ATTACH ROD INTO CENTER SUPPORT BY TURNING
4
SILVER COLOR BRACKET WHEEL.
1
2
4
7
8
6
Center Support
Projection may be adjusted, if needed, by loosening adjusting screws.
REMOVAL OF UNUSED CARRIER SLIDES
5
PROJECTION
Adjusting Screws
7
ATTACH SUPPORT TO THE ROD
The support arm goes over the top of the rod with
into the arm hook and locks in by turning the cam
the Philips screw.
TURN
HANG DRAPERIES
LOCK!
End brackets
3
Center Support
ONE WAY-CORD LEFT
INSTALL ROD INTO END BRACKET: drop end
of rod into the u-shaped clip of the end bracket. To
remove rod from bracket simply lift the rod out of
the u-shaped clip.
SPECIAL INSTRUCTION
1. TENSION PULLEY OPTION: can be
Tension Pulley to desired location, loop
cord onto pulley wheel. Grasp cord joining
knot behind Master Carrier and pull out
enough cord to take up slack between the
rod and the cord tension pulley. (Fig. 2)
Retie knot as close to the Master Carrier as
possible then cut o excess cord beyond
knot. Rotate pulley head until cords are in
proper alignment and release into pulley
base.
MOUNTING INSTRUCTIONS:
Wall mount option- Mount the one
1
end bracket and one support to the
wall at desired location. No center
support is needed for installations
less than 50” long. Ceiling mount
option- If rod is to be installed to the
ceiling, attach pulley housing (without
brackets) and stirrup portion of center
support directly to the ceiling.
FOR RODS FULLY EXTENDED TO
50” OR MORE, INSTALL CENTER
2
SUPPORT.
Spring clip
End bracket
Center Support End brackets
Push up the end gate to remove carrier slides
ONE WAY-CORD RIGHT
CHILD SAFETY CORD GUIDE: RODS WILL NOT WORK PROPERLY WITHOUT GUIDE INSTALLED
Guide is pre-attached to the cord. Mount the guide to the wall at the desired height using the included screw. Tighten the screw
6
until the cord slides through the device freely. (See Fig. 1) Remove excess slack on the cord by grasping and pulling down on the
knot that is on the back side of the master carrier. Pull the knot out until the cord is taught in the guide. Tie a new knot into the cord
as close as possible to the master carrier and cut o the excess cord. (See Fig. 2)
CHILD SAFETY CORD GUIDE REMOVAL: Pry open the three clips on the back of the device. (See Fig.3) Split the guide open
and remove the cord guide.
Fig. 1
2. CEILING INSTALLATION. If rod is to be installed to ceiling, attach pulley housings
(without brackets) and stirrup portion of center support directly to ceiling.
Stirrup
Pulley housing
Joining
Knot
Fig. 2
Knots
cut
Overlap
Master Carrier
WARNING
TO AVOID POSSIBLE STRANGULATION, KEEP CORDS OUT
OF REACH OF CHILDREN. USE THESE DEVICES:
!
1
2
3
Fig. 3
1. CLAMP OR CLOTHES PIN
2. CLEAT
3. TIE THE CORD TO ITSELF
4. TIE-DOWN DEVICE.
Loading...