Page 1
Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the store.
HARDWARE
INNER TABLE BOARDS WITH BRACE HOLES
2-EA
OUTER-TABLE & BENCH BOARDS
16 - 3 1/2” Bolts W/Washers & Nuts
(Not shown in actual size)
4-EA
2 - Ea. Table Cleats
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered defects.
Mallet or block of wood and
hammer
NOTE: Read all instructions before starting.
Helpful Tips:
A battery or electric drill will make assembly easier and faster.
Use a good quality penetrating oil or wood deck sealer with a UV
inhibitor and an anti-fungal.
STEP 1
Lay the four table boards on a clean dry surface, with the two inner
table boards with brace holes, in the center, and two of the outer
table boards on either side. Place boards with the sanded side down.
(As shown in figure 1. Note the position of the inner boards with
brace holes).
Lift each board and insert two of the 3 1/2” bolts into the predrilled
holes (Figure 1). Repeat on other end. Do not insert bolts into the
center holes.
TOOLS REQUIRED
9/16”
DEEP
WELL
SOCKET
NOTE: Using a battery
Or electric power drill
with a socket attach-
ment will make assembly
easier and faster.
Figure 1
BRACE HOLE
BRACE HOLE
UNSANDED SIDE UP!
STEP 2
Position the table cleats onto the 3 1/2” carriage bolts. (As shown in
figure 2). Place the flat side down and to the inside of the table.
Attach with washers and nuts. (Use a mallet or block of wood with
hammer if needed to set the cleat onto the bolts)
Use a deep well socket to tighten nuts, drawing carriage bolts flush
and snug to top of table. (Caution: be careful not to over tighten, as
bolt heads can pull too deeply into table top.)
Figure 2
Now proceed to step 2 on the instruction sheet included in second bag of hardware.
Loading...