Page 1
Keyboard And Mouse TrayArticulating
Arm Installation Instructions
Page 2
Mouse Tray
Power Driver with Square
Adjustable Torque
1
51708 x6
#2 Phillips Head
Driver Bit
2
50200 x2
Track square
#2 Square Head
Driver Bit
2 3
50016 x1
52490 x1
and back 3/8"
Tape Measure
4
5
50363 x2
1
1
Remove paper strips
and place track as
shown above.
2 OF 4
Page 3
Mouse Tray
Far right keyboard
tray position
Forward left
mouse position
5
Centered keyboard
tray position
Front
4
3
Far left keyboard
tray position
2
Forward right
mouse position
Back left
mouse position
Back right
mouse position
shown
3 OF 4
Page 4
Mouse Tray
Operation of the Keyboard and Articulating Arm Systems:
MFP21 Articulating Arm: For height adjustment, grasp the front and back edges of
the tray. Tilt the tray toward the back and lift up or push down. Release the tray to lock
it in place. To tilt the tray, turn the knob on the right hand side of the arm. The arm will
slide forward and back in the track, It will also rotate left and right on the swivel with a
moderate push.
MVS17 Articulating Arm: To operate the arm, loosen the knob on the right hand side.
Push the tray up or down to the desired height. Tilt to desired angle. Retighten the
knob. The arm will slide forward and back in the track. It will also rotate left and right
on the swivel with a moderate push.
MFSS22 Articulating Arm: To raise the tray, lift up on the tray. It will lock in place.
To lower the tray, tilt the tray back and push down. Release the tray to lock it in place.
To tilt the tray, turn the knob on the right hand side of the arm. The arm will slide
forward and back in the track. It will also rotate left and right on the swivel with a
moderate push.
MDA17 Articulating Arm: To raise or lower the tray, push the lever to the right and
move the tray to the desired height. Push the lever to the left to lock the arm in place.
To tilt the tray, pull out on the t-handle and tilt the tray to the desired angle. Release
the t-handle to lock the tray in place. The arm will slide forward and back in the track.
It will also rotate left and right on the swivel with a moderate push.
MFS17 Articulating Arm: To lower the tray, pull out on the ratchet lever and ratchet
the tray to the desired position. To raise the tray, lift up on the front. To tilt the tray,
loosen the ratchet lever. Tilt the tray to the desired angle and tighten the ratchet lever.
The arm will slide forward and back in the track. It will also rotate left and right on the
swivel with a moderate push.
MTLF Articulating Arm: To lower the tray, push in on the tray and push down. The
tray will stop at any height. To raise the tray, push in on the tray and raise up. To tilt
the tray, turn the knob on the right hand side until the tray is at the desired angle. The
tray will rotate left and right on the swivel with a moderate push.
4 OF 4
Loading...