Page 1
Roller Shades Inside Mount
Pocket
2)
Tear Drop
3)
Slim Bar
Products in the Roller Shade Package for Install:
Curved Insert Fascia
HOW TO INSTALL
Tools Needed for Install (not included in the roller shade package):
Pencil
Measuring Tape
Screwdriver
Drill
Level
OPTIONAL Hem Bars
Depending on your order, you will receive a shade with one of three
hem bars. All will be pre-installed and attached to the shade.
1) Heat sealed pocket with a weight inserted (you can remove
weight during install and return to the pocket when complete)
2) Tear drop
3) Slim bar
B
A
D
*A
C
C
D
1) Heat Sealed
– Shade x 1
A
*End caps, brackets and fascia come assembled and attached to shade
B – Chain Guide and Chain Guide Screw x 1
C – Brackets (Quantity varies based on width, See Step 1)
D – Screws 1-¼” #8 Hex Head x 4
*Use alternative fasteners for drywall, aluminum or concrete installs, not included
with blinds
Page 2
Roller Shades – Inside Mount – Curved Insert Fascia Installation Instructions
Front
3” 3”
1 Mark bracket location
Items Needed:
Pencil
Brackets
Hold one bracket, 3” from the side of the window, and mark both holes.
Repeat on the other side.
Space any remaining brackets evenly, not more than 25” apart. Ensure the
marks are level.
Position the bracket forward so the front hooks are outside your window sill
providing space for the curved insert fascia to latch. (See Step 4)
Mark the holes to drill with your pencil. Repeat on the other side.
Hooks
2 Drill holes
Items Needed:
Drill
Drill bit
Using the holes you marked in Step 1, drill each hole.
3 Screw in brackets
Items Needed:
Brackets
Screws
*Anchors for drywall, aluminum or concrete installs, not included with blinds
Screw each bracket into the holes you drilled in Step 2.
Page 3
Roller Shades – Inside Mount – Curved Insert Fascia Installation Instructions
Front
Groove
Clip
Hooks
4 Mount shade in brackets
Items Needed:
Shade
Hold the shade with the fascia facing you and the chain hanging down.
Front
Tilt the bottom of the shade toward you and position the front groove on the
front hooks of the brackets, as shown in Figure A.
Once the front groove is positioned securely over the front hooks of each
bracket, tilt the bottom of the shade toward the window until you hear the shade
click in place in the back clip of each bracket.
5 Install the chain guide
Items Needed:
Chain guide
Screw
Insert the chain into the chain guide clip.
Position the chain guide, allowing for some slack in the chain,
and attach with a screw through the hole in the bottom center.
Back
Figure A
6 Confirm roller shade operation
Raise the shade all the way up and lower the shade all the way down.
Raise the shade to a center position to ensure it locks in place and lower the
shade all the way down.
Loading...