Page 1
X-Base for Square & Round Tables- All models & sizes • INSTRUCTIONS
(MCBX22/30 (Cain Cafe), MVCTBX22/30 (Via Cafe), MTBX22/30/36 (Cain), MKTBX22/30/36 (Kobe))
Organize your parts.
Parts:
A: X-Base
Quantity: 1
B: Post
Quantity: 1
C: Spider
Quantity: 1
Hardware:
D: Feet (Cain & Via
Only)
Quantity: 4
D: Feet (Kobe Only)
Quantity: 4
E: Screws
Quantity: 8
IMPORTANT NOTICE:
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
Check to be sure that you have all parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Keep all hardware parts and packaging out of reach of children.
Any problems or questions call Regency Oce Furniture at 1-866-816-9822 or email customerservice@regencyof.com
Page 2
X-Base for Square & Round Tables- All models & sizes • INSTRUCTIONS
(MCBX22/30 (Cain Cafe), MVCTBX22/30 (Via Cafe), MTBX22/30/36 (Cain), MKTBX22/30/36 (Kobe))
Organize your parts.
STEP 1: Attach Feet (D) to bottom of X-Base (A).
A
D
STEP 2A:
Post (B).
STEP 2B: Attach X-Base (A) to bottom of Post (B) with
bolt & washer, tighten bolt.
Unthread single bolt & washer from bottom of
BB
A
B
A
STEP 3: Unthread bolts & washers from top of Post (B). STEP 4: Attach Spider (C) to top of Post (B) using bolts
and washers.
C
B
B
B
Any problems or questions call Regency Oce Furniture at 1-866-816-9822 or email customerservice@regencyof.com
Page 3
X-Base for Square & Round Tables- All models & sizes • INSTRUCTIONS
(MCBX22/30 (Cain Cafe), MVCTBX22/30 (Via Cafe), MTBX22/30/36 (Cain), MKTBX22/30/36 (Kobe))
Organize your parts.
STEP 5: Attach a Tabletop* to the assembled Base.
Start by placing the tabletop facedown and then nd
the center & mark it. Then, place the base in the
center of the top. The use the 8 Screws (E) in the 8
holes on the Spider (C) to attach the top to the base.
* Tabletop is not included with base purchase
STEP 5 Diagram 2: Round Tabletop Center
Measure and draw* from top to bottom and left to right
to nd the center.
STEP 5 Diagram 1: Spider (C) Hole Pattern
C
= Screw hole to use.
STEP 5 Diagram 3: Square Tabletop Center
Measure and draw* from corner to corner diagonally
to nd the center.
D D
* Make sure the drawings can be removed * Make sure the drawings can be removed
G
Any problems or questions call Regency Oce Furniture at 1-866-816-9822 or email customerservice@regencyof.com
Loading...