Page 1
Square/Round Table Top INSTRUCTIONS
Organize your parts. You will need a phillips head screw driver, crescent wrench, tape measure and pencil, drill(optional).
Two people are required for assembly.
A
Step 1: Screw 4 feet (F) into base (B) leg
ends.
A2
B
C
D
Step 2: Remove the nut from rod (E) and
set aside.
E
F
G
Step 3: Insert the rod(E) through the hole in
the base (B) and attach nut to exposed rod
end under base bottom.
A. Square Top
A2. Round Top
B. Large Base
C. Cylinder
D. Spider
E. Rod
F. Foot (4)
G. Screws (8)
STEP 4: Next place the cylinder (C) over the
exposed metal rod (E).
STEP 5: Place the exposed end of the metal
rod (E) through the hole in the spider (D) and
twist the second nut back onto the rod until
tight
Page 2
Step 6: Prepare your Template (INCLUDED) by adhereing both template pages to one another on the dashed line.
STEP 7: Turn Table Upside down. According to your table top(Square or Round) draw 2 diagonal lines across the table as shown below.
STEP 8: Place dot 1, located on the template, directly over the crossing lines.
1
1
Page 3
STEP 9: Once aligned, mark template dots 2,3,4,5 on table bottom.
STEP 10: Place table top
(A,A2) flat on the floor and
set the completed base
over the center.
2
3
1
4
5
4
5
2
3
1
STEP 11: Line Up the marks made on table from step 9 with the holes on the spider arms. Attach using 8 Screws(G) and flip table over.
2
3
2
3
1
4
5
4
5
1
4
5
2
3
1
IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have a ll parts and hardware.
Remove all wrapping materials, including staples & packing straps before you start to assemble.
Do not tighten all screws/bolts until completely assembled.
Keep all hardware parts out of reach of children.
Page 4
-The Outside dots are for 48” Table
2
tops and X-Bases.
-The Inside dots are for 30”, 36” and
42” Table tops and X-Bases.
3
1
LINE UP TOP EDGE OF SECOND SHEET HERE.
Page 5
4
5
Loading...