Symple Stuff QBFD1399 Installation & Assembly

Page 1
Assembly and Installation
Organize your parts. You will need a phillips head screw driver, pencil and measuring tape, drill(optional).
Two people are required for assembly.
Parts & Hardware: A: Table Top • B: T-base Leg(2) • C: Glides/Casters(4) • D: Screw(16)
(Depending on the product, PART C will be 4 Glides OR 4 Casters)
B
Step 1: Screw 2 Glides/Casters (C) into each T-base Leg (B).
B
Step 3: Prepare your Template (INCLUDED) by taping both
template pages to one another on the dashed line.
EXAMPLE
4”
LINE UP TOP EDGE OF SECOND SHEET HERE.
Step 2: On a clean flat surface, place desired finish of
Table Top(A) face down.
ALIGN THIS CORNER WITH TABLE TOP CORNER
9.5”
Page 2
STEP 4a:
Follow the Assembled Template for Leg Placement. The template for attaching the legs should be aligned
as shown below.
Leg #2
NOTE: Edges of template
align with edges of table.
Leg #1
STEP 4b: When T-base Leg is aligned with the template, Mark the four holes on Table top(A).
Step 5: Attach the T-base Leg(B) to the Table Top(A)
using 8 Screws(D) per Leg.
B
IMPORTANT NOTICE
Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched. Check to be sure that you have a ll parts and hardware. Remove all wrapping materials, including staples & packing straps before you start to assemble. Do not tighten all screws/bolts until completely assembled. Keep all hardware parts out of reach of children.
Page 3
4”
LINE UP TOP EDGE OF SECOND SHEET HERE.
Page 4
ALIGN THIS CORNER WITH TABLE TOP CORNER
9.5”
Loading...