Page 1
ASSEMBLING & INSTALLATION INSTRUCTIONS FOR PRODUCT# 6505 6506 6508
t
b
m
k
bar
r
d
t
r
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.2).
1. Return the arms to suitable position, see figure.2.
2. Attach the pipe(A) to the fixture body (B) by turning it clockwise until
tight.
3. Attach the glass shade (E) and collar ring(D) to the lamp holder , then
lock it securely with check ring (C).
4. Install the light bulbs in accordance with the fixture specifications
NOTE: DO NOT EXCEEDTHE SPECIFIED WATTAGE!
HANGING THE FIXTURE (Fig.1)
1. Shutoff the poweratthe circui
ceiling, including the old single bar.
2. Carefully unpac
3. Thread nipple (C) into loop (F) until snug.
4. Thread other end of nipple (C) with loop attached into single bar (D)
until snug.
5. Place lock washer (B) over end of nipple protruding through single bar
and thread hex nut (A) onto nipple until tight.
6. Take this single
junction box screws (E). Tighten screws securely with screwdriver.
7. Using prope
and connect to the fixture loop (I). Close the link.
8. By measuring, determine correc
hanging height. Using proper chain pliers disconnect and discard
remaining chain.
9. Lace the fixture wires through the chain.
10. Slip loop collar (H) over the chain, then do the same with the canopy
(G).
11. Open the other end link of the chain and hang the fixture on the loop
at the ceiling. Close the link.
12. Feed the fixture wires through the loop (F) and nipple (C) and pull
until taut.
13. Slide canopy (G) up flush to ceiling, secure using loop (H).
new fixture andlay all the parts on a clearsurface.
assembly andmountto ceiling junctionbox with
chain pliers to open one endlinkof the chain provide
reakerandremove oldfixture fro
numberof links neededforprope
CONNECTING THE WIRES (Fig.3)
Take the black wire from the ceiling junction box and the smooth wire
1.
leg from the fixture and twist bare ends together. Twist wire connector
onto end of wire until snug.
2. Repeat same process with white junction box wire and ribbed wire leg
of fixture wire. NOTE: Twist wires together in the same direction you
twist the wire connector onto wires.
3. If your junction box has a grounding wire (green or bare copper),
attach this wire and the bare copper wire from the fixture together as
step 1.If junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw on the single bar.
4. Tuck these wire connections neatly into the ceiling outlet box and then
raise the canopy (G) all the way to the ceiling. Raise the loop (H) and
thread onto ceiling loop protruding through canopy
Fig.1
Fig.2
Junction
Box(Ce iling )
A
B
D
C
E
F
G
H
CHAIN
I
A
B
C
D
E
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.3
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare Copper(Ground)
U
L
R
Listed
R
Loading...