Page 1
45° Sloped Ceiling Adaptor
Installation Instruction
READ AND SAVE THESE INSTRUCTIONS
A. To reduce the risk of electric shock, insure electricity has been
turned o at the circuit breaker or fuse box before beginning.
B. WARNING: To reduce the risk of personal injury, use only the two
steel screws (and lock washers) provided with the outlet box for
mounting to the outlet box. Most outlet boxes commonly used for the
support of lighting xtures are not acceptable for fan support and
may need to be replaced, consult a qualied electrician if in doubt.
C. The outlet box and support structure must be securely mounted
and capable of reliably supporting a minimum of 50 pounds. Use
only UL Listed outlet boxes marked FOR FAN SUPPORT
D. This unit accommoda
1. Install mounting plate to outlet box in ceiling using the screws and
washers provided with your outlet box. Remove the two canopy
mounting screws 180 degrees apart on outside edge of mounting
plate. Loosen the 2 remaining screws. This will make installation of
the canopy easier in step 5 & 6. (Fig. 1)
2. Remove the downrod ball that was supplied with your ceiling fan
by loosening the set screw. Slide the downrod ball o the downrd.
use with the slope ceiling adapter ball. (Fig. 2)
tes slopes of up to 45 degrees.
Outlet box
Mounting plate
Washers
.
3. Install the slope ceiling adapter ball to the existing downrod or new
longer downrod with the crosspin from your existing downrod. Push
ball up until it engages the crosspin and tighten set screws. (Fig. 3)
4. Feed motor lead wires through downrod/canopy assembly and
insert downrod into motor yoke. Make sure that the tab in the
canopy engages the notch in the downrod ball. Install downrod to
fan using instructions provided with your fan as this may vary from
model to model. (Fig. 4)
5. Carefully hang fan onto hook in mounting plate using one of the
two holes in the canopy. This will allow hands-free wiring. Refer to
your ceiling fan owners manual for wiring instructions. (Fig. 5)
ly
6. Careful
any wire connections. The canopy has 2 mating slots and 2 mating
holes. Position both slots in canopy directly under and in line with
2 mounting plate screws and lock washers. Lift fan until mounting
7. Rotate canopy clockwise until both mounting screws drop into slot
recesses. Tighten screws securely. Install third and fourth screws
with lock washers into mating holes and tighten. (Fig. 6)
Cross pin
Upper
set screw
lift fan from mounting plate hook, making sure not to break
Cross pin
Upper
set screw
Lower
set screw
Screws
Fig. 1 Fig. 2 Fig. 3
Tap
Downrod
ball
notch
Mating
slots
Fig. 4 Fig. 5
Fig. 6
Screws
Mating
holes
Loading...