Page 1
Padded Shower Seat, HC-3 & HC-4
Folding Seat with Grab Bar
Installation Instructions
Feature Highlights:
■ Seat capacity is 250 pounds.
■ Grab bar is designed and tested to
meet ADA standards.
Shower Seat Installation
■ Secure unit to wall with two
anges (3 fasteners each), and with
wall bracket (4 fasteners).
■ For installations on stud wall,
steel or berglass construction,
use in wall backing at all fastener
locations to comply with local
building codes.
■ For installation on solid walls, use
expansion anchors and screws in
compliance with local building
codes.
Note: Fasteners are not provided
by Symmons.
Shower Seat Operation
■ Shower seat folds up when not in
use and is retained upright by wall
bracket spring retainer.
■ Warning: to avoid damaging or
pulling seat out of the wall, sit down
gently. Do not drop down on seat
suddenly.
Compliance:
■ Americans with Disabilities Act
(ADA)
Grab Bar Construction
Tubing
■ Stainless steel contruction.
■ Exposed surfaces in satin nickel
nish.
Concealed Flange
■ 3” diameter ange furnished with
3 stainless steel set screws and one
backplate.
■ Flanges and center posts are heliarc
welded to tubing.
1 1/2" (38mm)
1 1/2" (38mm)
(38mm) diameter
1-1/2”
Warranty:
Limited Lifetime - to the original end
purchaser in consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty
for complete warranty information.
Grab Bar Installation
■ Secure to wall with three anges.
■ For installation on stud wall, steel or
berglass construction use in wall
backing at all fastener locations to
comply with local building codes.
■ For installation on solid walls, use
expansion anchors and screws in
compliance with local building codes.
Note: Fasteners are not provided by
Symmons.
■ Clearance is the distance between the
nished wall surface and the inner
edge of the tubing. e standard
clearance furnished is 1-1/2”
(38mm).
■ Dimensions are measured from
centerline to centerline of tubing,
unless noted on grab bar application
by circle dimensions which are from
centerline of tubing to wall.
Concealed Flange
Page 2
Dimensions Padded Shower Seat, HC-3 and HC-4
32”
813 mm
12”
305 mm
LH RH
14”
356 mm
18 1/2”
470 mm
17” - 19” (432 mm - 483 mm)
8 5/8”
219 mm
22”
559 mm
Note: Design and Dimensions subject to change without notice.
Dimensions Grab Bar for Padded Shower Seat, HC-3 and HC-4
32-1/4"
819 mm
6-3/4"
171 mm
20-1/4"
514 mm
1 1/8”
29 mm
s
s
s
11 1/2”
292 mm
s
control area
within 15" of
17" – 19"
432mm – 483mm
Top view
Note: Design and Dimensions subject to change without notice.
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ (800)796-6667 ■ Fax: (800)961-9621
©2014 Symmons Industries, Inc.■ www.symmons.com ■ gethelp@symmons.com ■ ZV-414 REV A 07/28/14
33" – 36"
838mm – 914mm
33" illustrated
38"
965mm
48"
1219mm
Loading...