Symmons 1-902-FSB User Manual

Page 1
®
HYDAPIPE
Surface Mounted Shower System
1-902S-FSB: Through wall piping configuration with soap dish 1-902-FSB: Through wall piping configuration less soap dish
Pressure Balancing mixing valve with screw driver service stops and adjust­able stop screw to limit handle turn. Fre-Flo, all brass, vandal resistant head with ball joint on institutional type head bracket. Levertrol lever diverter with volume control. Wall/hand shower with flexible 5’ metal hose with in-line vacuum breaker, wall connection and flange. 30” slide bar for hand shower mounting. Attached soap dish and sloped metal top cap. Stainless steel covering to be 18 gauge with #4 brush finish.
Modifications:
Valve:
Suffix 21: Single supply, manual shut off, 4 arm handle
Suffix 22: Single supply, manual shut off, lever handle
Suffix 60: Single supply, metering shut off (not ADA compliant)
Shower head:
Suffix 270: Fre-Flo, all brass, ball joint, adjustable spray
with volume control
Suffix 131: Super, ball joint, adjustable spray head
Suffix 121: Super, ball joint, adjustable spray head with volume control
Suffix 285: Fre-Flo, all brass, fixed spray (no ball joint)
Suffix OWBJ: One way ball joint
Suffix DSH: Additional shower head in lieu of hand spray unit
Soap dish:
Suffix CWM: Wall mounted cake soap dish
Suffix RS: Recessed soap dish
Hand spray accessories:
Suffix FS: Hand spray, hose and wall hook (in lieu of Suffix FSB)
Suffix QD: Quick disconnect for hand spray units
Suffix R: White vinyl hose in lieu of metal hose
Seat and Grab bars
Suffix HC1: Slat seat and two wall grab bar (right hand)
Suffix HC2: Slat seat and two wall grab bar (left hand)
Suffix HC3: Padded seat and two wall grab bar (right hand)
Suffix HC4: Padded seat and two wall grab bar (left hand)
(2)
(1)
SYMMONS PRODUCTS MEET
and flow rate requirements.
Shower Heads and Hand Showers
2.5 GPM (9.5 L/min)
Job/Location
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
Engineer
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
Contractor
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
Notes:
(1) ADA requirements for location of grab bar may obstruct access to
recessed soap dish. Wall mounted cake soap dish (CWM) alternative is available.
(2) ADA requirements state that the seat shall be located opposite the
controls. This will require the construction of a partial wall, or use of a reinforced partition for mounting the folding seat. Construction of a partial wall or reinforced partition to be provided by others.
Symmons Industries, Inc. 31 Brooks Drive Braintree, MA 02184 Phone: (800) 796-6667 Website: symmons.com
Copyright © 2015 Symmons Industries, Inc.
Fax: (800) 961-9621
Email: gethelp@symmons.com
ZV-1567 REV A 042216
Loading...