Symmons 1-50VT-FS User Manual

1-50VT-FS

Visu-Temp ® Tub and
Shower System with
Hand Spray

Visu-Temp® Pressure-Balancing mixing valve with integral thermom­eter and adjustable stop screw to limit handle turn. Tub spout. Lever
diverter with volume control for hand spray and tub spout. Wall/hand
shower with flexible 5’ metal hose, in-line vacuum breaker, wall connec­tion and flange. Wall hook for hand shower mounting.

Modifications:

Suffix X: Integral service stops—allows water shut-off at valve for

service

Suffix X-3/4 3/4” valve to increase flow approximately 20%

Suffix 6: 6’ hose in place of standard 5’ hose

Suffix B30: 30” adjusting bar in place of wall hook

Male 1/2" IPS thread must protrude 3/8" (10 mm) from
nished wall for proper installation of street ell and ange.

nished
wall

SYMMONS PRODUCTS MEET

ASME A112.18.1

AND ALL KNOWN FLOW RATE

REQUIREMENTS.

Shower Heads and Hand Showers

2.5 GPM (9.5 L/min)

6"

(152 mm)

Screw wall
hook into
stud or install
proper
backing.

5"

(127 mm)

min. without stops

7" (178 mm)

min. with stops

Note:
2-1/2" (64 mm) min. 3" (76 mm) max.
On 2" x 4" construction, use
2-1/2" (64 mm) min. rough-in. Valve
inlets and outlets are 1/2" (13 mm) IPS
connections.

approx.

(889 mm)

approx.

42"

(1067 mm)

oor line

35"

7"

(178 mm)

min.

hot and
cold inlets

22"

(559 mm)

see note

4"

(101 mm)

Note: Dimensions subject to
change without notice.

shower
discharge

3-1/2"

(89 mm)

Job/Location

. . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . .

Engineer

. . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . .

Contractor

. . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . .

This drawing to be used for rough-in installation
only. All floor to center dimensions optional.
Concealed piping and fittings not furnished by
manufacturer. For ADA compliance (Americans
with Disabilities Act) consult ADAAG or your
state regulations for proper product choice and
mounting locations. For complete installation,
adjustment and service information see installa­tion instructions.

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184
Phone: [phone]
www.symmons.com

Copyright © 2015 Symmons Industries, Inc.

■ Fax: [phone]

■ [e-mail]

■ ZV-1437 REV A ■ 090115