Symmons 1-3170VT-H401-V User Manual

1-3170VT-H401-V

Visu-Temp ® Tub and
Shower System with
Hand Spray

Visu-Temp® Pressure-Balancing mixing valve with Clear-Vue™
thermometer and adjustable stop screw to limit handle turn. Lever
diverter with volume control for shower head, hand spray and tub
spout. Euro-Flo single mode shower head with arm and flange. Tub
spout. Euro-Flo single mode wall/hand shower with flexible 5’ metal
hose, in-line vacuum breaker, wall connection and flange. Cradle for
hand shower mounting.

Modifications:

Suffix BRS: Radiance® polished brass finish

®

Suffix PCB: Polished chrome and Radiance

®

Suffix STN: Radiance

satin finish

Suffix X: Integral service stops—allows water shut-off at valve for service

Suffix X-3/4 3/4” valve to increase flow approximately 20%

Male 1/2" IPS thread must be recessed
1/4" (6 mm) from nished wall for proper
installation of street ell.

Screw wall hook

5-3/8"

(137 mm)

into stud or install
proper backing.

polished brass finish

nished
wall

8-1/2"

(216 mm)

shower
discharge

SYMMONS PRODUCTS MEET

ASME A112.18.1

AND ALL KNOWN FLOW RATE

REQUIREMENTS.

Shower Heads and Hand Showers

2.5 GPM (9.5 L/min)

Job/Location

. . . . . . . . . . . . . . . . . . . . . . . . . .

6"

(152 mm)

to suit

5" (127 mm)

min. without stops

7" (178 mm)

min. with stops

Note:
2-1/2" (64 mm) min. 3" (76 mm) max.
On 2" x 4" construction, use 2-1/2" (64 mm)
min. rough-in.

approx.
35-1/2"

(902 mm)

approx.

42"

(1067 mm)

oor line

22"

(559 mm)

7"

(178 mm)

min.

hot and
cold inlets

see note

4"

(101 mm)

Note: Dimensions subject to
change without notice.

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184
Phone: [phone]
www.symmons.com

■ Fax: [phone]

■ [e-mail]

3-1/2"

(89 mm)

. . . . . . . . . . . . . . . . . . . . . . . . . .

Engineer

. . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . .

Contractor

. . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . .

This drawing to be used for rough-in installation
only. All floor to center dimensions optional.
Concealed piping and fittings not furnished by
manufacturer. For ADA compliance (Americans
with Disabilities Act) consult ADAAG or your
state regulations for proper product choice and
mounting locations. For complete installation,
adjustment and service information see installa­tion instructions.

Copyright © 2015 Symmons Industries, Inc.

■ ZV-1447 REV A ■ 090215