Symmons 1-250VT-H401-V User Manual

Page 1

1-250VT-H401-V

NOTE: 2-1/2” (64mm) min. 3” (76mm) max. On 2”x4” construction, use 2-1/2” (64mm) min. rough-in. Valve inlets and outlets are 1/2” (13mm) IPS connections.

Male 1/2” I.P.S. thread must be recessed 1/4” (6mm) from finished wall for proper installation of street ell.

Visu-Temp ® Shower System with Hand Spray

Visu-Temp Pressure-Balancing mixing valve with Clear-Vue™ thermometer and adjustable stop screw to limit handle turn. EuroFlo single mode wall/hand shower with ﬂexible 5’ metal hose, in-line vacuum breaker, wall connection and ﬂange. Cradle for hand shower mounting. Polished chrome ﬁnish.

Modiﬁcations:

Sufﬁx BRS: Radiance® polished brass ﬁnish

Sufﬁx PCB: Polished chrome and Radiance® polished brass ﬁnish

Sufﬁx STN: Radiance® satin ﬁnish

Sufﬁx X: Integral service stops—allows water shut-off at valve for service

Sufﬁx X-3/4 3/4” valve to increase ﬂow approximately 20%

SYMMONS PRODUCTS MEET

ANSI A112.18.1M, EPA ‘92

AND ALL KNOWN FLOW RATE

REQUIREMENTS.

Shower Heads and Hand Showers

2.5 GPM (9.5 L/min)

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 (800) 796-6667, (781) 848-2250 ■ Fax (800) 9 6 1 - 9 6 21, (781) 8 4 3 - 3 8 4 9 Website: www.symmons. c o m ■ Email: c us t o me r s er v i c e @ sy m m on s . co m

Job/Location

. . . . . . . . . . . . . . . . . . . . . . . . . .

Engineer

. . . . . . . . . . . . . . . . . . . . . . . . . .

Contractor

. . . . . . . . . . . . . . . . . . . . . . . . . .

This drawing to be used for roughin installation only. All ﬂoor to center

dimensions optional. Concealed piping and ﬁttings not furnished by manufacturer. Dimensions are for ADA compliance (Americans with Disabilities Act) consult ADAAG or your state regulations for proper product choice and mounting locations. For complete installation, adjustment and service information see installation instructions.