Symbol LS 3020 Special Operating Instructions

LS 3020-I037A Special Operating Instructions

(70-04014-37)

Revision A: March 1994

Special Operating

Instructions



LS 3020-I037A Special Operating Instructions

(70-04014-37)

Revision A: March 1994

This version of the software enables the scan­ner to verify that the Motorola terminal is
ready before attempting a decode.

Defaults

Baud Rate: 2400
Stop Bits: 1
Laser Enable Mode: Disable

Laser Enable Mode

The Laser Enable Mode parameter indicates
whether the LS 3020 must establish communi­cation with the Motorola terminal prior to at­tempting a decode. If this parameter is
enabled, the following sequence occurs when
the trigger is pulled:

• The scanner sends an ENQ (05H) to
the terminal.

• The decode LED flashes to indicate the
scanner is waiting for acknowledg­ment from the terminal. The LED
stops flashing when ACK (06H) or
NAK (15H) is received, or the trigger
is released.

• If an ACK is received, the unit at­tempts a decode.

• If a NAK is received, the unit issues
four short low beeps.

2-4

LS 3020-I037A Special Operating Instructions

(70-04014-37)

Revision A: March 1994

Aiming LEDs and Trigger Posi­tions

The LS 3020-I037A does not generate an aim­ing LED.

An aiming LED is provided for the
LS 3020LR-I037 or LS 3020ALR-H037 when
the trigger is pulled. These scanners support
a two-position trigger to allow the user to aim
prior to activating the motor.

When the trigger is pulled in the first position,
the aiming LED is generated. If the trigger is
not pulled to the second position, the aiming
LED turns off after approximately two sec­onds.

Triggering and Laser Enable
Mode

If the Laser Enable Mode is disabled, the scan­ning motor is activated as soon as the trigger
is pulled to the second position.

If Laser Enable Mode is enabled and the trig­ger is not pulled to the second position, the
aiming LED remains on for two seconds, and
the unit does not transmit an ENQ. If the trig­ger is pulled to the second position, the unit
transmits the ENQ to the terminal.

• If an ACK is received, the unit at­tempts a decode.

• If a NAK is received, the aiming LED
is turned off, and the unit issues four
short low beeps.

• If the unit does not receive an ACK or
NAK, the aiming LED remains on for
two seconds. The decode LED contin­ues to flash until an ACK or NAK is re­ceived.

3-4

LS 3020-I037A Special Operating Instructions

(70-04014-37)

Revision A: March 1994

Laser Enable Mode

To enable or disable this parameter:

1. Scan the

ENABLE LASER MODE

code.

2. Scan either

3. Scan

ENTER

ENABLE LASER MODE

ENABLE

.

ENABLE

or

DISABLE

bar

.

DISABLE

ENTER

4-4