SYMA F3 2.4G, F3 2.4 ghz Instruction Manual

Main Features:

Single blade for more flexible, fast flight and better wind
resistance, fly outdoor or indoor.

Features gyroscopic stabilization technology for smooth, easy-to­control flight.

Easy to install and repair.

Specifications, material in this brochure are for reference only, any
different please check with our website www.symatoys.com

RC Helicopter Instruction Manual

2.4G

AGES 14+

PREFACE

1

Dear customer,
Thank you for buying SYMA’s product. For your quickly grasp the operating
performance of this product， please read the instructions carefully and
keep it.

IMPORTANT NOTE

1.This not a general toys，but a precision rc helicopter which is a
combination of professional and technical as machinery, electronics,
aerodynamics, and high-frequency transmitter. Please install it according
to the instruction. We will not respond for any lost of mistake operation.

2.This product suit for everyone fly rc helicopter well and over 14 years.

3.Fly avoid drafts, forced air, water, strong fans heat and air conditioning
vents.

4.Syma will not responsible for any issue cause by improper operationor
using.

5.If you have any problem on operation, flight or repair , please contact our
local distributer ,we will provide technical support and after-sales service.

WARMING

Please keep flying helicopter away from crowd. The incorrect installation,
improper operation and electronic equipment malfunction will cause the
damage or injury. Please keep in mind of flight.

1. Please fly away from crowd or drafts.

2. Please avoid water or humid environments

3. Fly in correct according to the instruction.

4. Please avoid rotating parts in high speed and heat.

5. Please turn on/off the power as the instruction shows as below,
incorrect operation will be dangerous even cause the injury.

Battery installation

PACKING LIST

Head cover

Remote
control

USB charging
wire

Li-Polymer batteries

2

Body frame

Unscrew and remove battery cover from RC unit. Insert 4 ‘AA’ batteries,
noting polarity indicators. Replace battery door cover.

Battery cover

4 X 1.5V
‘AA’batteries

Main blades
(include tail
blade)

Charger case

ASSEMBLY OF BATTERY TO HELICOPTER

level surface

Insert fully charged battery into the
socket and press tight.

3

Precautions

1. When the indicator of controller is lit state, but the helicopter indicator is
flashing, it means the helicopter fail to match the signalwith controller .You
need to turn off controller and helicopter and turn on them again to match
signal.

2. When the helicopter fail to hover and always turn around, please re-start
the controller and helicopter.

3.Make sure the battery installed into the helicopter well within 10 seconds
when the controller opening ,or you can not complete the code .

4.Indicator on the helicopter lights off or lights flashing when the helicopter
crashing obstructions

Step one: Open the controller ,then controller ticking and indicator flashes

quickly

Step Two: Install the battery into the battery case , then set the helicopter

on a level surface ,indicator will flash two times the first slow , then indicator
becomes to Medium-speed flash.

Step Three: Push the controller throttle to the top ,and then pull it to the

low-end ,ticking sound once again ,indicators on the helicopter and controller
lighting up ,which means that the success of the codes