Sylvania SIP220 User Manual

MODEL NO. SIP220

PORTABLE DOCKING STATION FOR iPOD

INSTRUCTION MANUAL

PLEASE READ BEFORE OPERATING THIS EQUIPMENT

Warnings and Precautions

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.

This symbol, located on back or bottom of the unit, is intended to alert the
user to the presence of un-insulated “dangerous voltage” within the product’s’s
enclosure that may be of sufficient magnitude to constitute a risk of electric
shock to persons.

This symbol, located on back or bottom of the unit, is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.

Any use of the controls or an adjustment to the procedures other than those
specified herein may result in hazardous radiation.

CAUTION : TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE

OF PLUG TO WIDE SLOT, FULLY INSERT.

To reduce the risk of electric shock, do not remove cover (or back). There are no
user-serviceable parts inside. Please refer any servicing to qualified service personnel.

WARNING: Changes or modifications to this unit not expressly approved by the

party responsible for compliance could void the user’s authority to operate the
equipment.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designedo provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between he equipment and receiver.

•

Connect he equipment into an outlet on a circuit different from that to which the
receiver s connected.

•

Consult the dealer or an experienced radio/TV technician for help.

2

Features

3

Features Defined

1

iPod Docking Station Connect your iPod, Pod mini, or iPod nano.

2

VOLUME Press the up arrow to increase the volume, and the down arrow to decrease volume.

3

POWER Press the POWER button to turn the radio off or on.

4

STOP/BAND Press the BAND/STOP button to switch between AM or FM radio stations, or stop iPod

playing.

5

FUNCTION Press the FUNCTION button to witch between Radio and Aux-in control.

6

EQ Press the EQ button to switch equalizer modes between Classical, Jazz, Rock, and Pop.

7

AC Cord (120V/60 Hz) The attached AC (Alternating Current) cord provides power to the player.

8

Battery Back-Up(2xAA batteries) The Battery Back-Up will save the clock and alarm settings in case

of power outage. The display will not be active without AC power (batteries not included). NOTES: DO

NOT MIX OLD AND NEW BATTERIES.

9

FM Antenna The FM Wire Antenna provides flexibility and range when adjusting the FM reception.

An AM Antenna is built into the player.

10

SEARCH/TUN Press the SEARCH/TUNE down or up buttons to decrease/increase the radio frequency,

or to decrease/increase the clock time.

11

iPod Press the iPod button to power on an iPod and enable control through the player.

12

PLAY/PAUSE/P+ Press the PLAY/PAUSE/P+ button to play or pause an iPod, or to cycle up through

the preset radio stations.

13

DISPLAY In radio mode press the display button to watch between viewing the time or the radio

frequency.

14

ALARM SET 2 Use the ALARM SET 2 button to view and adjust the alarm-2 time, and to set alarm-2

to buzzer, radio, or iPod.

15

ALARM SET 1 Use the ALARM SET 1 button to view and adjust the alarm-1 time, and to set alarm-1

to buzzer, radio, or iPod.

16

MEM/CLK SET Press the MEM/CLK SET button to program a radio station into the presets, or to

adjust the clock.

17

SNOOZE Press the SNOOZE button to delay the alarm for five minutes after the alarm sounds. Press

the SNOOZE button to set the player to turn off after 10-90 minutes (SLEEP function).

18

LCD View the Time, AM indicator, iPod Indicator, and radio frequency through this Liquid Crystal

Display.

19

AUX-OUT Use the Aux-Out jack to connect the player to external speakers.

20

AUX-IN Use the Aux-in jack to connect an iPod shuffle or other audio device to the player.

21

DIMMER Toggle the DIMMER witch between HI and LO to adjust the brightness of the LCD Display.

4