OPERATING INSTRUCTIONS
45 SECONDS ANTI-SHOCK
PORTABLE CD PLAYER
WARNING: TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
OPERATING
INSTRUCTIONS
45 SECONDS ANTI-SHOCK
PORTABLE CD PLAYER
CAUTIONCAUTIONCAUTIONCAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
This compact disc player is classified as a CLASS
1 LASER product.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1 LASER APPARAT
Invisible laser radiation when open and
interlocks defeated. Avoid exposure to
beam.
PRECAUTIONSPRECAUTIONSPRECAUTIONSPRECAUTIONS
To maintain good performance
Do not use the unit in places which are extremely
hot, cold, dusty or humid, In particular, do not use
or keep the unit in following places.
in a high humidity area such as a bathroom
near a heater
in an area exposed to direct sunlight (e. g., inside
a parked car, where it can become extremely
near sources of strong magnetism, such as televi sions, speakers, or magnets
where there is a lot of movement or vibration,
such as on a car dashboard or an unstable shelf
hot)
For safety
Do not attempt to disassemble this unit. Laser rays
f om the optical pickup are dangerous to the eyes
r
Make sure that pins or other foreign objects do
not get inside the player
Take care not to drop the unit or subject it to
strong shocks
To keep dust f om the pickup lens, keep the disc
compartment lid closed after use. Never touch
the lens
If you hear no sound when playing a disc, DO
NOT turn the volume up high because the music
could suddenly begin at high volume. To avoid
hurting your ears or damaging the speakers, turn
the volume control to the lowest level before
starting playback and slowly turn it up to the
desired level
Note on listening with the headphones
NoteNoteNote ononon listeninglisteninglistening withwithwith thethethe headphonesheadphonesheadphones
Listen at moderate volumes to avoid hearing
damage
Do not wear the headphones while driving or
cycling. lt may create a traffic hazard
You should use extreme caution or temporarily
discontinue use in potentially hazardous situations,
such as walking, jogging, etc
r
CAUTIONCAUTIONCAUTIONCAUTION
Listening to headphone stereo at full power for
extended periods of time can result in hearing
damage
Do not touch pickup lens
Note on condensation
NoteNoteNote ononon condensationcondensationcondensation
lf the unit is suddenly moved from a cold place
to a warm one, it may cause in condensation
on the pickup lens and malfunction or playback
difficulties, should this occur, leave the unit for
a few hours, then try playback again.
USING ON DRY CELL
BATTERIES A
Open the battery compartment and insert two LR6
(size AA) alkaline batteries with the and marks
correctly aligned.
Battery replacement
The battery indicator in the display
the remaining power of the batteries. Replace the
batteries when lights. If the unit remains in use
after lights. the operation will stop.
If the cover of the battery compartment
comes off
Note on dry cell batteries
Do not mix the different types of batteries, or an
old battery with a new one
To prevent the risk of electrolyte leakage or
explosions, never recharge the batteries, apply
recharge
When not using the batteries, remove them to
pre
vent needless battery wear
If liquid leaks from the batteries,
to
remove
Not included.
according
B
heat to them, or take them apart, must set
button to "OFF".
wipe thoroughly
A
USING ON RECHARGEABLE
BATTERIES C
Be sure to use size AA Ni-Cd 1.2V rechargeable
batteries. which are commercially available
Be sure to read the instructions of the
rechargeable batteries before use
Before charging the batteries, close the disc
compartment, you cannot charge the batteries
to
while it is opened
Only for the special rechargeable batteries
which expose part on the polarity.
1. Insert the rechargeable batteries with the and
marks correctly aligned.
2.
When recharge please switch the recharge button
to "on", after recharging or in other condition switch
to "off ", otherwise the CD player will be damaged
3. Connect the AC adaptor.
1 to DC 4.5 V jack
2 to a wall outlet
4. Press STOP to start charging.
After charging, disconnect the AC adaptor.
Time to recharge the batteries
Recharge the batteries when
remains in use after
will stop.
ATTENTION
The rechargeable batteries are recyclable, At the end
of their useful life, it may be illegal to dispose the
batteries into the municipal waste stream under
various state and local laws. Check with your local
solid waste officials in your area for details about
recycling options or proper disposal.
Not included.
lights, If the unit
lights, the current operation
.
Not included.
purchased
B
C
Ni-Cd
OFFON
CHARGE
Cd
2
DC 4.5V
1
BEFORE PLAYBACK
HOLD switch
Release the
When not using the unit, set the HOLD switch to the
ON position, Accidentally pressed button will not
function. If buttons are pressed when the HOLD
switch is set to the ON position. "HOLD" will light on
the display.
Turning on and off
Turning the power on
Press PLAY/PAUSE. Power is turned on and
playback starts.
Turning off the power
If no new operations are done within seconds
from the end of last operation, the power is turned
off automatically. (Auto power off function) you can
turn off the power before it is automatically turned
off by pressing STOP
Standby mode
When an operation finishes, the unit goes into standby
mode until the auto power off function automatically
turns off the power.
To enter standby mode, press PLAY/PAUSE to
start playback, then press STOP
Adjusting the sound
Volume
Turn the VOLUME control to adjust the volume.
X-BASS
Switch on the X-BASS for extra bass emphasized.
Inserting a disc F
1. Push the OPEN switch to open the disc compartment
2. Place a disc in the center with the label side facing up.
3. Close the disc compartment.
To remove the disc
Pick up the disc, holding its edge, while pressing
the pivot gently.
D
switch to
HOLD
D
E
E
position before playback.
OFF
D
G
30
D
E
BASS
F
G
PLAYBACK H
Connect the supplied headphone to the
1. Release HOLD to OFF position.
2. Place a disc.
3. Press PLAY/PAUSE
Playback starts from the first track.
BASIC OPERATION
To stop: Press STOP
To pause: Press PLAY/PAUSE
To resume, press it again.
To search for the
beginning of a track: Press or
desired
To locate a
passage:
Release the button until the
PHONE
jack.
Keep
start of desired passage.
or
Pressed.
H
111
111
333
222
333
222
MODE KEY:
NORMAL REPEAT ONE REPEAT ALL
SHUFF INTRO
REPEAT ONE: " 1"light on display
and will repeat the track you selected
REPEAT ALL: " ALL" light on display
and will repeat entire tracks
INTRO:
and will play the first lights on display
10 seconds of each track
SHUFF: "SHUFF" light on display
Plays every tracks in random order
ANTI SHOCK: light on display until
Press again then change to normal play
PROGRAM:
1. At STOP mode,
"PROG 00" start flashing.
2. Press skip /searched or key to search the
track No.
3. When desired track is display, press PROGRAM
key to register, Then track No. display to "00" again.
4. Repeat 2-3 (up to 20 tracks) after register 20 tracks.
display shows the first registered track.
5.
Registered tracks can be check by press PROGRAM
key, And it can be changed by repeat 2-3.
6. Press play key, then PROG stops flashing and starts
playing.
7. Open the door or power off to clean programing
At stop mode,press until "INTRO"
if no disc then "No Disc" is displayed.No Disc:
Press PROGRAM key, Then
CONNECTION TO AN
EXTERNAL UNIT
Use a commercially available connection cord which
has a 3.5mm stereo plug at one and two phono
plugs at the other end.
Connect the stereo plug to the LINE OUT jack
of the unit and connect the phono plugs to the analog
input (AUX) terminals of the external unit.
NOTE
Turn off the power of both units before connection.
DO NOT connect to the PHONO(magnetic pickup)
inputs of an amplifier.
Volume and bass boost on this unit have no effect
on the line output.
I
end
I
MAINTENANCE
To clean the lens
If the lens become dirty, the player will skip or not
play, If this occurs, clean the lens in the following.
manner, To remove dust or dust particles, first use a
camera lens blower/brush 1 to blow a few times to
loosen particles, then gently brush the lens 2 clean
finish by blowing the lens again.
Note
Take care not to get too much solution on the swab.
which could flow into the unit and cause damage.
Pressing too strongly with the swab could scratch
or break the lens.
To clean the discs
Before playing, wipe the disc from the center out
with a cleaning cloth, After playing, store the disc
in its case.
J
J
K
1
LINE OUT
LINE IN
CD IN
AUX
22
K
SPECIFICATIONS
Tracking system 1-beam laser
Laser pickup Semiconductor laser
D/A conversion 8-times oversampling digital fillter
+1- bit DAC
Frequency response
20-20,000 Hz
Outputs PHONES: stereo jack (3.5mm)
[ , 32 ohms at 1
kHz]
Input DC 4.5V for external power from
AC adaptor: Not included.
Power DC 3V fr m Alkaline batteries
(2 x AA or LR6): Not included.
DC 2.4V from the rechargeable
batteries: Not included.
Dimensions 142 x 29(H) mm
Weight 210 grams (9.8 oz.) without
batteries
Supplied accessory
Stereo headphones (1)
The specifications and external appearance of this
unit are subjected to change without notice.
20mW+20mW
o
9
( 5 /16x 1 /8 inches)
1
SUBJECT TO MODIFICATION WITHOUT NOTICE!
Loading...