SYGAMA TECHNOLOGY XL750 User Manual

IBomb Party

Amp up your party anywhere

U S E R G U I D E

FCC ID:AXE-XL750
IC:11118A-XL750

Model:XL750

MODE

VOLUME DOWN
PREVIOUS
TRACK

PLAY/PAUSE

ANSWER CALL

The Bluetooth wordmark and logo areregistered
trademarks owned by Bluetooth SIG, Inc.

NEXT
TRACK

VOLUME UP

Setup your

IBomb Party

1 IBomb Party
1 User Guide

Turn on bluetooth on your device a nd
search for the “IBo mb Party”, selec t

PAIRING MODE

Switch to the “ON” position, the LED Display will show “Blue”,
indicating that IBomb Party is in pairing mode.

If you are prompted to enter a password to complete pairing,
enter “0000”

it to connect to play m usic.

TUR N ON

LED display HI

If the IBomb Party is moved out of range, start again to
re-enter the connection.

CHANGE INPUT MODE

Press “MODE” buon to switch/change play music mode
among TF card, U-disk, AUX FM and bluetooth.

Plug the included 3.5mm audio cable into the IBomb Party
and then connect your source
(e.g: MP3 player, Tablet, Computer, etc.)

Play/Pause/Answer call

MODE

Vol+

Change play music mode
(Bluetooth/TF card/U-disk/Aux)

Short press to previous track
Long press to fast backward

Short press to next track
Long press to fast forward

Volume down

Vol-

Volume up

When y our call co ming, ple ase p ress
“ ” butt on to pick up y our call.

FAIL TO PAIR

Make sure the device is in pairing mode and the Bluetooth
is working. Please reset (ON/OFF)the power switch
again.

IBomb Party

Device only works with Micro SD
card up to 32GB

Play your music
anywhere you go

directly from the device
using the micro sd slot/U-disk.



This device complies with part 15 of the FCC rules. Operation is subject to the following

two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.



This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.





