Syba SD-UEN-5SL User Manual

Installation Manual

Introduction

This 5.25” enclosure is designed to provide a solution to connect
existing storage devices such as 3.5” IDE hard drive, MO drives,
CD devices or DVD devices to USB2.0 or Firewire 1394a, an ideal
interconnect for multimedia application. This 5.25” enclosure can
provide peak data transfer rate up to 480Mbps for USB 2.0
interface and 400Mbps for Fire wire 1394a interface.

Features

General

z Support plug-n-play. Hot- Swap and Wake-UP.
z Accommodate all existing storage devices such as 5.25” IDE

hard drives.

z Support Self power mode.
z Support Windows98. 98SE, ME, 2000 and XP operating

system.

USB 2.0 (For USB 2.0 & Combo version)

z Compliant with Universal serial Bus Specification Revision

2.0

z Compliant with ATA/ATAPI-6 Specification
z Support LBA 48, PIO Mode 0-4, DMA Mode 0-2, UDMA Mode

0-5

z Compliant with USB Mass Storage Bulk only Specification 1.0

z Support High-Speed (480Mbps) and Full-Speed (12Mbps)

mode

Firewire IEEE1394a (Combo version)

z Compliant with IEEE1394-1995 and 1394a standard for high

performance serial bus

z Sustained IDE rate at 25Mbytes/sec (200Mbps), Peak

transfer rate at 50Mbytes/sec (400Mbps)

z Compliant with ATA/ATAPI-6 Specification
z Support PIO Mode 0-4, DMA mode 0-2, UDMA mode 0-5
z Support SBP-2 and ATA/ATAPI Protocols

What is in your package?

Please check whether the package contains following items:

z One 5.25” Enclosure
z Installation Manual
z USB 2.0 (Type ‘A’ to Type ‘B’) cable (USB 2.0 & Combo

version only)

z Firewire 1394a (6pin to 6pin) cable (Combo version only)
z AC-DC Power Supply 12VDC
z Screws for securing the enclosure and 3.5” hard drive or

CD/DVD devices

z Driver CD

z Pads (Optional)

If any item is missing or damaged, please contact the retailer as

soon as possible.

Notice: For all existing storage devices such as 3.5’’ IDE hard

drives, please make sure the JUMPER setting set to
MASTER before installing into 5.25” Enclosure.

(However, for certain hard drives, you may need to set

the jumper as “Cable Select”.)

HARDWARE INSTALLATION
Installing a CD/DVD devices into the 5.25’’ enclosure
Step 1:

Slowly remove the rear
cover

Step 2: