VertiPoint Electric
Pencil Sharpener
Operating
Instructions
Please read the following instructions
before operating your sharpener.
Sharpening
The Sword sh VertiPoint sharpener is supplied
with a 9 Volt DC power adaptor. Plug the
adaptor into a convenient 13 Amp socket
and insert the jack-plug into the socket on
the rear of the sharpener.
Operating Instructions
● Insert a standard 8mm pencil into the
sharpener.
● The sharpener will start to operate. When
the pencil is sharp, the sharpener will stop,
automatically.
● To empty the sharpener, remove the top
cover and upturn the machine over a waste
bin.
● Please note that a safety interlock prevents
the sharpener from running when the top
cover is removed.
● Do not allow the shavings tray to over- ll
as this can cause permanent damage to
the sharpener mechanism.
Caution
● Adult supervision required.
● Do not insert a nger into the sharpener as
this may cause injury.
● This is a pencil sharpener. Do not insert any
other object.
● Do not immerse this sharpener in water.
Clean or replace the blade assembly
WARNING - the edges of the helical
blade are sharp!
●
Remove the top cover.
● Loosen the three screws that secure the
blade support cage and remove it.
For troubleshooting and
product support, please visit
www.snopakebrands.com
● Insert the new blade.
● Replace the blade support cage. Note that
the raised rib at the top of the cage must
face forward.
● Replace the shavings tray cover before
using the sharpener.
● Lift out the old blade. Take care not to
lose the foam ring (A).
A
Loading...