Alcove Bathtub with Apron
®
w ell made for e v e r
INSTALLATION INSTRUCTIONS
www.swissmadison.com | 1-434-623-4766 | info@swissmadison.com
@SwissMadison
#WellMadeForever
ALCOVE BATHTUB INSTALLATION INSTRUCTIONS
PRIOR TO INSTALLATION:
· Inspect bathtub to ensure no damages have occurred while in shipping.
· Observe all plumbing and building codes in accordance with your state and local requirements.
· All dimensions are nominal! Be sure to measure your bathtub prior to installation.
· The step-by-step guidelines in the installation instructions are a general reference. Should there be
any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss
Madison products by hiring a licensed professional.
· Read installation and maintenance instructions thoroughly before installing. Be sure to use proper
tools and always wear proper personal safety accessories for your protection.
· Two people are recommended to handle and install this product as it is fragile.
· Make sure all wood studs and supports are properly installed.
· Verify all the necessary plumbing is installed by a certified plumber.
· Floor drain and trap are not included
.
If you have any questions or concerns please contact us:
1-434-623-4766
info@swissmadison.com
SUGGESTED TOOLS & MATERIALS: INCLUDED PARTS:
Safety
Glasses
Tape
Measure
Square Caulk Gun
Level Screwdriver
Adhesive Drop ClothSealant
Utility
Knife
— 1 —
Screws
Alcove
Bathtub
Support
bars
ALCOVE BATHTUB INSTALLATION INSTRUCTIONS
1. Rough-In
· Rough plumbing must be pre-installed by a
certified plumber before installation.
· If floor drain-hole installation is needed,
contact a certified plumber.
· Place tub at final desired location and verify
floor drain and bathtub drain align.
Wall studs
W
6” x 12”
Rough
cutout
12”
2. Attach Support Bars
· If your model does not come with bars pre
attached, please attach them according to the
included Apron Support Installation Sheet
before continuing to Step 3.
· If the bars are pre attached, please continue to
follow all the steps listed.
2a. Flip tub upside-down using a drop cloth to
help prevent damages.
6”
L
Studs must be
flush and square
Drop Cloth
2b. Cut zip tie and line up the support bar with
the pre-drilled hole in the apron. Then use
the screws to securely attach the support
bar to the apron. Repeat this for the rest of
the support bars.
— 2 —
ALCOVE BATHTUB INSTALLATION INSTRUCTIONS
2c. If the hole on the support bar does not line
up with the pre-drilled holes in the apron,
please complete the following steps:
- Using a screwdriver, loosen the screws
holding the hinge in place. Do not remove
the screws completely.
- Once the hinge can move, reposition the
support bar so the holes are aligned.
- Re-tighten the screws for the hinges to re
secure the support bar to the bathtub.
- Use the screw to securely attach the
support bar to the apron.
3. Ensure Tub is Level
· Place level across the bottom surface of the
apron and the adjustable feet to verify the tub
is level. If it is not, adjust the feet accordingly.
Do this for all adjustable feet.
· Carefully flip tub over into the upright position.
Reverify that the tub is level.
— 3 —
ALCOVE BATHTUB INSTALLATION INSTRUCTIONS
4. Mark & Pre-Drill Hole Locations
· Mark stud locations.
· Pre-drill Ø5 mm holes on top flange.
· If stud is not flush to flange, a shim should be
used. This will fix any gaps to prevent cracking
the flange.
5. Screw Into Place
· Lay mortar bed and carefully lower bathtub into
predetermined location.
· Secure tub by screwing flange into the pre-drilled
holes from step 4.
· Place drop cloth in bathtub and stand inside bathtub
to press it into floor when securing to wall studs.
Shim, less
than ¹⁄8” gap
1-¹⁄4” screws
(panhead or
roundhead)
6. Install Plumbing Fixtures
· Once your bathtub is in place, securely fasten
and connect your waste and overflow then
check for leaks. Standard 1 ¹⁄2" waste and
overflow sold separately.
· Use latex/acrylic sealant, gasket or non-staining
plumber’s putty to seal between drain and
bathtub.
Overflow
— 4 —
1-434-MADISON
®
w ell made for e v e r
(623-4766)
www.swissmadison.com
ONE YEAR LIMITED WARRANTY
Swiss Madison® products are made with quality materials and excellent craftsmanship to provide our
customers with beautiful, durable, long-lasting products. Should there be any defects in materials or
craftsmanship under regular use that are discovered within the first year of installation, Swiss Madison®
will provide replacement parts at no charge, or at its discretion, replace any product or part of the product
that is deemed defective, under normal installation, use, service or maintenance. This warranty applies
only to the original purchaser. Proof of purchase will be required in the instance of a claim.
Swiss Madison® recommends all installations of Swiss Madison® products to be conducted by a
licensed, professional plumber or contractor. Swiss Madison® will not be held responsible for any
damage or product failure due to improper installation, misuse, or failure to utilize a licensed professional
for installation. Swiss Madison® is not responsible for any installation or removal costs.
This One Year Limited Warranty Will Be Voided If:
• The installation recommendations were not followed by the installer
• The product has been moved from its initial place of installation
• The product has in any way been modified from its packaged state
• The product has been subjected to improper maintenance, abuse, misuse, excessive use of
chemicals, accidents, or other damages, etc.
Swiss Madison® makes no implication that its products comply with any local building or plumbing
codes. It is the consumer’s responsibility and obligation to determine local code compliance prior to and
during installation. This warranty extends only to the original purchaser and first consumer.
Swiss Madison® is not responsible for any special, incidental or consequential damages associated with
the installation, replacement, return or use of the original purchaser’s product. This includes, but is not
limited to: freight costs, labor, travel time, lost profit, home damages and other contingent liabilities and
costs (including, without limitation, costs associated with ‘professionals’ or ‘experts’, investigations,
audits, analyses, attorneys and any other professional/hired services).
The Swiss Madison® warranty is a comprehensive and explicit limit of liability. All items not disclosed
within the warranty are not addressable within the responsibility of Swiss Madison®. Certain states have
variances regarding implied warranties; in those situations, we remain fully compliant.
If you have any questions or concerns, please contact us directly at
1-434-MADISON (623-4766)
WARNING: Contents of your order may contain sharp and possibly other harmful pieces and may
cause hazard to children and adults. Swiss Madison® is not responsible in any way for personal
damages.
Loading...