Swiss Madison SWMD1146 Owner Manual

Wall-Mount Sink

INSTALLATION INSTRUCTIONS

well made forever

@SwissMadison

#WellMadeForever

www.swissmadison.com | 1-434-623-4766 | [e-mail]

WALL MOUNT SINK INSTALLATION INSTRUCTIONS

PRIOR TO INSTALLATION:

· Inspect sink to ensure no damages have occurred while in shipping.

· Observe all plumbing and building codes in accordance with your state and local requirements.

· All dimensions are nominal! Be sure to measure your sink prior to installation.

· The step-by-step guidelines in the installation instructions are a general reference. Should there be

any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss
Madison products by hiring a licensed professional.

· Read installation and maintenance instructions thoroughly before installing. Be sure to use proper

tools and always wear proper personal safety accessories for your protection.

· Two people are recommended to handle and install this product as it is fragile.

· These fixings are suitable for solid walls only. Plasterboard or stud walls may require specialist

fixings (not supplied).

· Care should be taken when drilling walls and floors to avoid any concealed wires or pipes.

·

If you have any questions or concerns please contact us:

1-434-623-4766

[e-mail]

SUGGESTED TOOLS & MATERIALS:

Safety

Glasses

Level

Drill

Pencil

Tape

Measure

INCLUDED PARTS:

Wall-Mount

Sink

Anchors

Bolts

— 1 —

WALL MOUNT SINK INSTALLATION INSTRUCTIONS

Anchor Metal Screw Plastic Gasket Metal Gasket Metal Nut

1a. Locate studs in the wall. If studs do not line up with

the sink’s mounting holes, additional support
backing is needed behind the finshed wall.

2. Push an anchor into each hole.

1b. Measure the distance between the center of each

mounting hole on the back of the sink. Use this
measurement to draw 2 marks onto the wall in the
desired mounting location. Use a level to make sure the
marks are level with the floor. Drill 2 holes according to
the marks using a 14 mm masonry drill bit to a depth of
75 mm.

3. Screw a fixing bolt into each fixing plug using a 8 mm

spanner until the spanner contacts the wall.

— 2 —

WALL MOUNT SINK INSTALLATION INSTRUCTIONS

4. Place the basin in position against the wall. Locating the fixing bolts through the holes in
the rear of the basin. Push a plastic washer followed by a metal washer, onto each fixing bolt.

5. Screw metal nut onto each fixing bolt to secure the basin. Do not overtighten, as this may
damage the ceramic.

6. Ensure sink is secure, tighten bolts if necessary. Install faucet and drain using
manufacturer’s instructions. Connect to water supply and check for leaks.

— 3 —

WALL MOUNT SINK INSTALLATION INSTRUCTIONS

HALF PEDESTAL WALL-MOUNT
SHROUD INSTALLATION:

1. Slide shroud into place, then mark location of holes located

on both sides of the shroud.

2. Pre-drill into wall and install achors. 3. Slide shroud into place and secure using same

steps as when mounting the sink. Use cover
caps to hide hardware. Do not overtighten, it
may crack the ceramic.

— 4 —

well made forever

(623-4766)

www.swissmadison.com

ONE YEAR LIMITED WARRANTY

Swiss Madison products are made with quality materials and excellent craftsmanship to provide our cus­tomers with beautiful, durable, long-lasting products. Should there be any defects in materials or crafts­manship under regular use that are discovered within the first year of installation, Swiss Madison will
provide replacement parts at no charge, or at its discretion, replace any product or part of the product
that is deemed defective, under normal installation, use, service or maintenance. This warranty applies
only to the original purchaser. Proof of purchase will be required in the instance of a claim.

Swiss Madison recommends all installations of Swiss Madison products to be conducted by a licensed,
professional plumber or contractor. Swiss Madison will not be held responsible for any damage or prod­uct failure due to improper installation, misuse, or failure to utilize a licensed professional for installation.
Swiss Madison is not responsible for any installation or removal costs.

This One Year Limited Warranty Will Be Voided If:

• The installation recommendations were not followed by the installer

• The product has been moved from its initial place of installation

• The product has in any way been modified from its packaged state

• The product has been subjected to improper maintenance, abuse, misuse, excessive use of
chemicals, accidents, or other damages, etc.

1-434-MADISON

Swiss Madison makes no implication that its products comply with any local building or plumbing codes.
It is the consumer’s responsibility and obligation to determine local code compliance prior to and during
installation. This warranty extends only to the original purchaser and first consumer.

Swiss Madison is not responsible for any special, incidental or consequential damages associated with
the installation, replacement, return or use of the original purchaser’s product. This includes, but is not
limited to: freight costs, labor, travel time, lost profit, home damages and other contingent liabilities and
costs (including, without limitation, costs associated with ‘professionals’ or ‘experts’, investigations,
audits, analyses, attorneys and any other professional/hired services).

The Swiss Madison warranty is a comprehensive and explicit limit of liability. All items not disclosed
within the warranty are not addressable within the responsibility of Swiss Madison. Certain states have
variances regarding implied warranties; in those situations, we remain fully compliant.

If you have any questions or concerns, please contact us directly at

1-434-MADISON (623-4766)

WARNING: Contents of your order may contain sharp and possibly other harmful pieces and may

cause hazard to children and adults. Swiss Madison is not responsible in any way for personal
damages.