Page 1
www.ESP.swisherinc.com
OWNER’S
MANUAL
SRAC20338
Adjustable
Gun Rack
Starting Serial #: L115-001001
20355 REV 15-001
SWISHER ACQUISITION INC.
1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093
PHONE 660-747-8183 FAX 660-747-8650
Made In The
USA
of US and Global Parts
Page 2
LIMITED WARRANTY
The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects
in materials and workmanship for a period of one (1) year from the date of purchase by the original
consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to
materials or workmanship. This warranty is subject to the following limitations and exclusions:
1) Limitation This warranty applies only to products which have been properly
assembled, adjusted, and operated in accordance with the instructions
contained within this manual. This warranty does not apply to any
product of Swisher that has been subject to alteration, misuse, abuse,
improper assembly or installation, shipping damage, or to normal
wear of product.
2) Exclusions Excluded from this warranty are normal wear, normal adjustments, and
normal maintenance.
All transportation charges, damage, or loss incurred during transportation of parts submitted for
replacement or repair under this warranty shall be borne by the purchaser. Should you have any
questions concerning this warranty, please contact us toll-free at 1-800-222-8183. The model
number, serial number, date of purchase, and the name of the authorized Swisher dealer from whom
you purchased the product will be needed before any warranty claim can be processed.
THIS WARRANTY DOES NOT APPLY TO ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES AND ANY IMPLIED WARRANTIES ARE LIMITED TO THE SAME TIME
PERIODS STATED HEREIN FOR ALL EXPRESSED WARRANTIES. Some states do not
allow the limitation of consequential damages or limitations on how long an implied warranty may
last, so the above limitations or exclusions may not apply to you. This warranty gives you specific
legal rights and you may have other rights, which vary from state-to-state. This is a limited warranty
as defined by the Magnuson-Moss Act of 1975.
2
Page 3
Safety Precautions
• NEVER allow children to play in or around the Safety Shelter.
• NEVER store flammable materials or fuel in your Safety Shelter.
• Keep a flashlight(s) or other battery operated lights inside the Safety Shelter. Check or
replace the batteries in these lights twice per year.
• Do not store any items in a manner that would block any of the Safety Shelter vents.
• We suggest stocking your Safety Shelter with provisions and supplies so that it is
ready when needed.
• During a high wind event occupants MUST stay at least 3” away from the walls and
door and remove all loose items from shelves and walls by placing them on the floor to
avoid potential injury from debris impact.
• Make sure stored firearms are not loaded.
• Use a safety device such as a trigger lock or cable lock on stored firearms.
• Keep the Safety Shelter locked while storing firearms.
• Do not stand on the gun rack or use it as a step.
• Do not use the gun rack as a seat.
• Recommended weight capacity 100 lbs.
Recommended Tools For Assembly:
• Leather Gloves
• Safety Glasses
• Flashlight
• (1) Torque Wrench Capable of 31 Ft-lbs
• (1) 9/16” Socket
• (1) 1/2” Open End Wrench or Socket Wrench
• (2) 7/16” Open End Wrench or Socket Wrench
Tip: If you’re adding this Accessory to an existing Safety Shelter, remove the appropriate
original nuts and bolts from the Wall Panels and replace them with the hardware provided
with the Accessory.
3
Page 4
This Gun Rack is designed
Item #
Part #
Description
to be installed on one wall
panel of ESP Safety
Shelters.
Step 1
Parts List
1 20341* Side - Adj Rack, Lower Left
2 20236 Bolt - Carriage 5/16-18 X .75
3 20342* Side - Adj Rack, Lower Right
4 20339* Base - Adj Rack
5 20237 Nut - Serr Flange 5/16-18
6 19799 Nut - Serr Flange, Hex 3/8-16
7 20349* Side - Adj Rack, Upper Left
8 20348* Side - Adj Rack, Upper Right
9 19828 Bolt - Carriage 3/8-16 X 1
10 20350* Plate - Face, Barrel Rest
11 20343* Plate - Face, Stock Rest
Step 2
Step 3
INSTALLATION INSTRUCTIONS:
1. Loosely assemble Base 20339 to
Lower Left Side 20341 and Lower
Right Side 20342 using 5/16-18 X .75
Bolt 20236 and 5/16-18 Nut 20237.
2. Attach Lower Base Assembly (from
Step 1), Upper Left Side 20349 and
Upper Right Side 20348 to the flanges
of one of the wall panels using 3/8-16
Nut 19799 and 3/8-16 X 1 Bolt 19828.
Make sure to tighten this hardware to
31 Ft-lbs, then tighten the hardware
from Step 1.
3. Next, connect Barrel Rest Plate 20350
to the Upper Side Brackets and Stock
Rest Plate 20343 to the Lower Side
Brackets using 5/16-18 X .75 Bolt
20236 and 5/16-18 Nut 20237. Note
the orientation of the Stock Rest Plate.
Make sure the Stock
Rest Plate is oriented as
shown with these three
square holes located
toward the bottom.
When ordering replacement parts:
*= USE PAINT CODE: GT=GREY
4
Page 5
This Gun Rack is designed
Item #
Part #
Description
to be installed on one wall
panel of ESP Safety
Shelters.
Parts List
2 20236 Bolt - Carriage 5/16-18 X .75
5 20237 Nut - Serr Flange 5/16-18
Edge Trim, 3.125"
12 20402
13 20351* Bracket - Barrel Rest
14 20346* Weldment - Stock Rest
15 20295 Pin - Ø.250 X .400
16 20292 Bolt - 1/4-20 X .75
17 20293 Washer - SAE Flat 1/4
18 20291* Bracket - Gun Retainer
19 20294 Nut - 1/4-20 2-Way Lock
Edge Trim, 7.625"
Edge Trim, 16.25"
Step 4
Step 5
Barrel Rest Bracket
20351 can be installed
with the flange facing
downward as shown or it
can be installed facing
upward.
INSTALLATION INSTRUCTIONS:
4. Install Stock Rest 20346 and Barrel
Rest 20351 in the desired height
positions using 5/16-18 X .75 Bolt
20236 and 5/16-18 Nut 20237.
5. Assemble Retainer Bracket 20291 to
each Barrel Rest using 1/4-20 X .75
Bolt 20292, 1/4 Washer 20293 and
1/4-20 Nut 20294 in the order shown.
Secure the Retainer Bracket with Ø.25
X .400 Pin 20295.
Edge Trim 20402
is preinstalled at
the factory.
When ordering replacement parts:
*= USE PAINT CODE: GT=GREY
5
Page 6
ALSO AVAILABLE
Visit www.ESP.swisherinc.com for details.
Single Panel Shelf
SRAC20221
Double Panel Shelf
SRAC20226
Bench
SRAC20229
Gun Rack
SRAC20282
6
Page 7
ALSO AVAILABLE
Visit www.ESP.swisherinc.com for details.
Dorcy Motion Sensor Light
SRAC20389
FLEXiT Light
SRAC20270
Kaito Emergency Radio
SRAC20390
Eva-Dry Dehumidifier, up to 500 cu-ft
SRAC19840
7
Page 8
www.ESP.swisherinc.com
OWNER’S
MANUAL
SRAC20338
Adjustable
Gun Rack
WHEN ORDERING PARTS, PLEASE HAVE THE
FOLLOWING INORMATION AVAILABLE:
* PRODUCT - ________________
* SERIAL NUMBER - _______________
* MODEL NUMBER - _______________
* PART NUMBER WITH PAINT CODE
* PART DESCRIPTION
TELEPHONE - 1-800-222-8183
FAX - 1-660-747-8650
SWISHER ACQUISITION INC.
1602 CORPORATE DRIVE
WARRENSBURG, MO 64093
Loading...