Swisher SRAC20282 User Manual

www.ESP.swisherinc.com

OWNER’S

MANUAL

SRAC20282

Gun Rack

Starting Serial #: L115-001001

20298 REV 15-001

SWISHER ACQUISITION INC.

1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093

PHONE [phone] FAX [phone]

Made In The

USA

of US and Global Parts

LIMITED WARRANTY

The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects
in materials and workmanship for a period of one (1) year from the date of purchase by the original
consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to
materials or workmanship. This warranty is subject to the following limitations and exclusions:

1) Limitation This warranty applies only to products which have been properly
assembled, adjusted, and operated in accordance with the instructions
contained within this manual. This warranty does not apply to any
product of Swisher that has been subject to alteration, misuse, abuse,
improper assembly or installation, shipping damage, or to normal
wear of product.

2) Exclusions Excluded from this warranty are normal wear, normal adjustments, and
normal maintenance.

All transportation charges, damage, or loss incurred during transportation of parts submitted for
replacement or repair under this warranty shall be borne by the purchaser. Should you have any
questions concerning this warranty, please contact us toll-free at 1-800-222-8183. The model
number, serial number, date of purchase, and the name of the authorized Swisher dealer from whom
you purchased the product will be needed before any warranty claim can be processed.

THIS WARRANTY DOES NOT APPLY TO ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES AND ANY IMPLIED WARRANTIES ARE LIMITED TO THE SAME TIME
PERIODS STATED HEREIN FOR ALL EXPRESSED WARRANTIES. Some states do not

allow the limitation of consequential damages or limitations on how long an implied warranty may
last, so the above limitations or exclusions may not apply to you. This warranty gives you specific
legal rights and you may have other rights, which vary from state-to-state. This is a limited warranty
as defined by the Magnuson-Moss Act of 1975.

2

Safety Precautions

• NEVER allow children to play in or around the Safety Shelter.

• NEVER store flammable materials or fuel in your Safety Shelter.

• Keep a flashlight(s) or other battery operated lights inside the Safety Shelter. Check or
replace the batteries in these lights twice per year.

• Do not store any items in a manner that would block any of the Safety Shelter vents.

• We suggest stocking your Safety Shelter with provisions and supplies so that it is
ready when needed.

• During a high wind event occupants MUST stay at least 3” away from the walls and
door and remove all loose items from shelves and walls by placing them on the floor to
avoid potential injury from debris impact.

• Make sure stored firearms are not loaded.

• Use a safety device such as a trigger lock or cable lock on stored firearms.

• Keep the Safety Shelter locked while storing firearms.

• Do not stand on the gun rack or use it as a step.

• Do not use the gun rack as a seat.

• Recommended weight capacity 100 lbs.

Recommended Tools For Assembly:

• Leather Gloves

• Safety Glasses

• Flashlight

• (1) Torque Wrench Capable of 31 Ft-lbs

• (1) 9/16” Socket

• (1) 1/2” Open End Wrench or Socket Wrench

• (2) 7/16” Open End Wrench or Socket Wrench

Tip: If you’re adding this Accessory to an existing Safety Shelter, remove the appropriate
original nuts and bolts from the Wall Panels and replace them with the hardware provided
with the Accessory.

3

This Gun Rack is designed

Item #

Part #

Description

to be installed on one wall
panel of ESP Safety
Shelters.

Step 1

Step 2

Parts List

1 19799 Nut - Serr Flange, Hex 3/8-16
2 20290* Side - Gun Rack, Upper Left
3 20289* Side - Gun Rack, Upper Right
4 19828 Bolt - Carriage 3/8-16 X 1
5 20285* Side - Gun Rack, Lower Left
6 20286* Side - Gun Rack, Lower Right

Edge Trim, 3.125"

7 20402

8 20287* Top - Gun Rack

9 20237 Nut - Serr Flange 5/16-18
10 20283* Base - Gun Rack
11 20236 Bolt - Carriage 5/16-18 X .75
12 20292 Bolt - 1/4-20 X .75
13 20293 Washer - SAE Flat 1/4
14 20295 Pin - Ø.250 X .400 Effective
15 20291* Bracket - Gun Retainer
16 20294 Nut - 1/4-20 2-Way Lock

Edge Trim, 7.625"
Edge Trim, 13.875"

Edge Trim 20402
is preinstalled at
the factory.

INSTALLATION INSTRUCTIONS:

1. Assemble Upper & Lower Left Sides 20290 & 20285 and Upper & Lower Right Sides

20289 & 20286 to one of the wall panels using 3/8-16 X 1 Bolt 19828 and 3/8-16 Nut

19799. Make sure to tighten this hardware to 31 Ft-lbs.

2. Attach Base & Top Brackets 20283 & 20287 to the Sides using 5/16-18 X .75 Bolt

20236 and 5/16-18 Nut 20237.

3. Next, connect Retainer Bracket 20291 to the Top Bracket using 1/4-20 X .75 Bolt

20292, 1/4 Washer 20293 and 1/4-20 Nut 20294 in the order shown. Use Pin 20295
to secure the Retainer Bracket.

When ordering replacement parts:
*= USE PAINT CODE: GT=GREY

4

Step 3

ALSO AVAILABLE

Visit www.ESP.swisherinc.com for details.

Single Panel Shelf

SRAC20221

Double Panel Shelf

SRAC20226

Bench

SRAC20229

Adjustable Gun Rack

SRAC20338

5

ALSO AVAILABLE

Visit www.ESP.swisherinc.com for details.

Dorcy Motion Sensor Light

SRAC20389

FLEXiT Light

SRAC20270

Kaito Emergency Radio

SRAC20390

Eva-Dry Dehumidifier, up to 500 cu-ft

SRAC19840

6

NOTES:

7

7

www.ESP.swisherinc.com

OWNER’S

MANUAL

SRAC20298

Gun Rack

WHEN ORDERING PARTS, PLEASE HAVE THE

FOLLOWING INORMATION AVAILABLE:

* PRODUCT - ________________
* SERIAL NUMBER - _______________
* MODEL NUMBER - _______________
* PART NUMBER WITH PAINT CODE
* PART DESCRIPTION

TELEPHONE - 1-800-222-8183

FAX - 1-660-747-8650

SWISHER ACQUISITION INIC.

1602 CORPORATE DRIVE

WARRENSBURG, MO 64093