The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects
in materials and workmanship for a period of one (1) year from the date of purchase by the original
consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to
materials or workmanship. This warranty is subject to the following limitations and exclusions:
1)LimitationThis warranty applies only to products which have been properly
assembled, adjusted, and operated in accordance with the instructions
contained within this manual. This warranty does not apply to any
product of Swisher that has been subject to alteration, misuse, abuse,
improper assembly or installation, shipping damage, or to normal
wear of product.
2)ExclusionsExcluded from this warranty are normal wear, normal adjustments, and
normal maintenance.
All transportation charges, damage, or loss incurred during transportation of parts submitted for
replacement or repair under this warranty shall be borne by the purchaser. Should you have any
questions concerning this warranty, please contact us toll-free at 1-800-222-8183. The model
number, serial number, date of purchase, and the name of the authorized Swisher dealer from whom
you purchased the product will be needed before any warranty claim can be processed.
THIS WARRANTY DOES NOT APPLY TO ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES AND ANY IMPLIED WARRANTIES ARE LIMITED TO THE SAME TIME
PERIODS STATED HEREIN FOR ALL EXPRESSED WARRANTIES. Some states do not
allow the limitation of consequential damages or limitations on how long an implied warranty may
last, so the above limitations or exclusions may not apply to you. This warranty gives you specific
legal rights and you may have other rights, which vary from state-to-state. This is a limited warranty
as defined by the Magnuson-Moss Act of 1975.
2
Page 3
Safety Precautions
•NEVER allow children to play in or around the Safety Shelter.
•NEVER store flammable materials or fuel in your Safety Shelter.
•Keep a flashlight(s) or other battery operated lights inside the Safety Shelter. Check or
replace the batteries in these lights twice per year.
•Do not store any items in a manner that would block any of the Safety Shelter vents.
•We suggest stocking your Safety Shelter with provisions and supplies so that it is
ready when needed.
•During a high wind event occupants MUST stay at least 3” away from the walls and
door and remove all loose items from shelves and walls by placing them on the floor to
avoid potential injury from debris impact.
•Do not stand on the shelf or use it as a step.
•Do not use the shelf as a seat.
•Recommended weight capacity 75 lbs.
Recommended Tools For Assembly:
•Leather Gloves
•Safety Glasses
•Flashlight
•(1) Torque Wrench Capable of 31 Ft-lbs
•(1) 9/16” Socket
•(1) 1/2” Open End Wrench or Socket Wrench
Tip: If you’re adding this Accessory to an existing Safety Shelter, remove the appropriate
original nuts and bolts from the Wall Panels and replace them with the hardware provided
with the Accessory.
3
Page 4
Item #
Part #
Description
This Shelf is designed to be
installed on two wall panels
of ESP Safety Shelters.
Step 1
Parts List
119799Nut - Serr Flange, Hex 3/8-16
219828Bolt - Carriage 3/8-16 X 1
320225*Side - Shelf, Left
420224*Side - Shelf, Right
520236Bolt - Carriage 5/16-18 X .75
620227*Base - Double Panel Shelf
720237Nut - Serr Flange 5/16-18
820228*Gusset - Shelf
Shelf Base 20227 can
be installed with the
flange facing downward
as shown or it can be
installed facing upward.
Step 2
Step 3
INSTALLATION INSTRUCTIONS:
1.
2.
3.
When ordering replacement parts:
*= USE PAINT CODE: GT=GREY
Attach Left Side Panel 20225 and Right Side Panel 20224 to the flanges of two of the wall panels using 3/8-16 Nut 19799
and 3/8-16 X 1 Bolt 19828. Make sure to tighten this hardware to 31 Ft-lbs.
Next, assemble Shelf Base 20227 to the Side Panels using 5/16-18 Nut 20237 and 5/16-18 X .75 Bolt 20236.
Then, connect Gusset 20228 to Shelf Base 20227 using 5/16-18 Nut 20237 and 5/16-18 X .75 Bolt 20236. Connect the
Gussets to the wall flange as shown using 3/8-16 Nut 19799 and 3/8-16 X 1.25 Bolt 19829 and tighten to 31 Ft-lbs.
4
Page 5
Visit www.ESP.swisherinc.com for details.
Single Panel Shelf
ALSO AVAILABLE
SRAC20221
Bench
SRAC20229
Gun Rack
SRAC20282
Adjustable Gun Rack
SRAC20338
5
Page 6
ALSO AVAILABLE
Visit www.ESP.swisherinc.com for details.
Dorcy Motion Sensor Light
SRAC20389
FLEXiT Light
SRAC20270
Kaito Emergency Radio
SRAC20390
Eva-Dry Dehumidifier, up to 500 cu-ft
SRAC19840
6
Page 7
NOTES:
7
7
Page 8
www.ESP.swisherinc.com
OWNER’S
MANUAL
SRAC20226
Double Panel Shelf
WHEN ORDERING PARTS, PLEASE HAVE THE
FOLLOWING INORMATION AVAILABLE:
* PRODUCT - ________________
* SERIAL NUMBER - _______________
* MODEL NUMBER - _______________
* PART NUMBER WITH PAINT CODE
* PART DESCRIPTION
TELEPHONE - 1-800-222-8183
FAX - 1-660-747-8650
SWISHER ACQUISITION INC.
1602 CORPORATE DRIVE
WARRENSBURG, MO 64093
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.