Swisher PBP-3580 User Manual

PBP-3580

Polaris Models Magnum 325 2X4 4X4 02 Expedition 425 4X4 02 Magnum 500 4X4 02

May fit additional models see Master List

Front

Caution: Do not exceed 5 MPH with the blade or it’s brackets installed

Remove the mount plate for trail riding where extra ground clearance is needed

1602 Corporate drive P.O. Box 67 Warrensburg, MO 64093 1-877-627-5860

13058

Assembly Instructions Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need

to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..

1. Remove the front skid plate. Trim the edge back to the factory notch as shown (Approximately ¾ Inch). Replace the skid Plate. Tighten securely.

2. Place the four U Bolts over the frame on each side with one in front of the front foot peg support, and one behind.

3. Place the mount plate up against the frame and attach the washers and nuts. Note locate the plate as shown with the front label toward the front. (Tabs are offset to the left slightly)

4. Tighten all bolts securely.

Remove edge of skid plate as shown

Item # Description Part #

1 Mount Plate 10611TK 2 U Bolt 7873Z 3 Washer Flat NB275 4 Nylock Nut 5/16-18 NB181 5 Hair Pin #39 NB127 6 Clevis Pin 10305

Factory Notch

Front