Swisher PBP-3570 User Manual

PBP-3570

Polaris Models

325 Magnum 2X4 & 4X4 01 & Older 425 Expedition 4X4 00 500 Magnum 4X4 01 & Older 500 Magnum RMK 4X4 02

May fit additional models see Master List

Front

Caution: Do not exceed 5 MPH with the blade or it’s brackets installed

Remove the mount plate for trail riding where extra ground clearance is needed

1602 Corporate drive P.O. Box 67 Warrensburg, MO 64093 1-877-627-5860

13183

Assembly Instructions Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need

to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..

1. Assemble Right Mount Plate and Left Mount plate to the Cross Plate using Carriage bolts ( Item 9), and Nylock Nuts ( Item 10) and snug the fasteners .

2. Place the mount plate up against the frame with the front toward the front of the ATV

3. Drop the U Bolts over the foot rest supports on the right side and attach with Nylock Nuts .

4. Place the long bolts ( Item 7 ) into Strap Bar (Item 4 ) and place the close spaced bolts over the rear foot rest support on the left hand side. Attach with Nylock Nuts.

5. Align the plate to the center of the ATV and tighten all hardware securely.

Item # Description Part #

1 Mount Plate Right 10608TK 2 Mount Plate Left 10609TK 3 Cross Plate 10453TK 4 Strap Bar 10454TK 5 Clevis Pin 10305 6 Hair Pin #39 NB127 7 Bolt 5/16-18 X NB138 8 U Bolt 5/15-18 7873Z 9 Carriage Bolt 10216

10 Nylock Nut NB181

Front