Swisher PBB-7530 Parts list

PBB-7530

Bombardier Models 330 Outlander 04 400 Outlander Max 04 400 Outlander 4X4 03-05

May fit additional models see Master List

Partial Frame View

Front

Caution: Do not exceed 5 MPH with the blade or it’s brackets installed

Remove the mount plate for trail riding where extra ground clearance is needed

1602 Corporate drive P.O. Box 67 Warrensburg, MO 64093 1-877-627-5860

12990 Rev 06-312

Assembly Instructions Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need

to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..

1. Place the mount plate up against the bottom of the frame. The Blade Mounting Tabs should be pointing down and located toward the front of the ATV.

2. Align the rear holes with the holes in the frame. Install the M8 Bolts and Nuts, just snug.

3. Install Carriage bolts into plate (Item2) and place on top of the frame aligning with the holes in the front of the plate. Snug up with Nuts (Item 4)

4. Center plate under the bike and tighten the bolts securely

1 Mount Plate 10518TK 2 Front Strap Plate 10324TK 3 Carriage Bolt NB517 4 Nylock Nut 5/16-18 NB181 5 Hair Pin #39 NB127 6 Clevis Pin 10305 7 Bolt M8-1.25 X 25 NB723 8 Nut M8-1.25 NB718