Swisher PBA-6510 Parts list

PBA-6510

Arctic Cat Models 250, 300, & 400 Models 02 and older 454 Models 98 & older 500 Models 02 & Older

May fit additional models see Master List

Front

Caution: Do not exceed 5 MPH with the blade or it’s brackets installed

Remove the mount plate(s) for trail riding where extra ground clearance is needed

1602 Corporate drive P.O. Box 67 Warrensburg, MO 64093 1-877-627-5860

12987 REV 06-307

Partial Frame View

Assembly Instructions Note. Right and Left direction are from the operator position. The lower skid plate, If so equipped, may need

to be removed. Please retain plate and hardware to be reinstalled if the plate is removed..

Arctic Cat 250 Assembly Instructions 1 Remove 4 foot peg bolts. (Retain for future use) 2 Install Right Hand Bracket with the mounting tab

down and to the front. with new bolts spacing it out from the frame with two(2) washers (item 3)

3 Install Left Hand Bracket with new bolts and one

washer (Item 3) to space it away from the frame.

4 Snug all hardware, then check for proper spacing

of mounting tabs, (14 3/16 to 14 1/4 outside to outside) remove washers if necessary.

5 Tighten all hardware.

All other listed ATV’s

1. Remove the 4 foot rest bolts. On the 500 Automatic, you may need to loosen the front bolts to assist in the mounting.

2. With the mounting tabs toward the front, mount the brackets using the longer bolt and lock washers provided. See Figure 2

3. Tighten all hardware

Item # Description Part #

1 Right Mount Plate 10302TK 2 Left Mount Plate 10300TK 3 Washer Flat NB272 4 Lock Washer 10146 5 Hair Pin #39 NB127 6 Clevis Pin 10305 7 Bolt M10-1.25 X 30 10304