Swisher LSRB11534 User Manual

swisherinc.com

OWNER’S

MANUAL

MODEL NO.

LSRB11534

STARTING SERIAL #:

L114-041001

LOG

SPLITTER

Safety

IMPORTANT

Read and follow all Safety Precautions and Instructions before operating this equipment.

REV 14-041

1602 CORPORATE DRIVE, WARRENSBURG MISSOURI 64093

PHONE 660-747-8183 FAX 660-747-8650

Manufacturing quality lawn care equipment since 1945

Assembly Operation Service and Adjustment Repair Parts

Made In The

USA

19226

LIMITED WARRANTY

The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects in materials and workmanship for the period's shown below beginning from the date of purchase by the original consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or workmanship. This warranty is subject to the following limitations and exclusions:

Engine Warranty All engines utilized on our products have a separate warranty extended

to them by the individual engine manufacturer. Any engine service difficulty is the responsibility of the engine manufacturer and in no way is Swisher, or its agents responsible for the engine warranty. Engine

warranty and contact information is as shown in the engine owners manual. Hydraulic System 1 Year Materials and Workmanship 3 Years Commercial Use The warranty period for this product when used for commercial or rental is

limited to 1 year from the date of original purchase. Limitation This warranty applies only to products which have been properly

assembled, adjusted, and operated in accordance with the instructions

contained within this manual. This warranty does not apply to any

product of Swisher that has been subject to alteration, misuse, abuse,

improper assembly or installation, shipping damage, or to normal wear of

product. Exclusions Excluded from this warranty are normal wear items, normal or routine

adjustments, and normal or routine maintenance.

In the event you have a claim under this warranty, you must return the product to an authorized service dealer. All transportation charges, damage, or loss incurred during transportation of parts submitted for replacement or repair under this warranty shall be borne by the purchaser. Should you have any questions concerning this warranty, please contact us toll-free at 1-800-222-8183. The model number, serial number, date of purchase, and the name of the authorized Swisher dealer from whom you purchased the splitter will be needed before any warranty claim can be processed.

THIS WARRANTY DOES NOT APPLY TO ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES AND ANY IMPLIED WARRANTIES ARE LIMITED TO THE SAME TIME PERIODS STATED HEREIN FOR ALL EXPRESSED WARRANTIES. Some states do not allow the limitation of

consequential damages or limitations on how long an implied warranty may last, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights, which vary from state-to-state. This is a limited warranty as defined by the Magnuson-Moss Act of 1975.

ABLE OF CONTENTS

WARRANTY………………....….2

SAFETY..……………………….3-4 TOWING..….……..……………..5 OPERATION……………………6-8

MAINTENANCE.…………………….8 DECALS…..………….……………….9 PARTS BREAKDOWN…………….10-13 SPECIFICATIONS..…………………15

SAFETY PRECAUTIONS

When you see this symbol, carefully read the message that follows and be

This Safety Alert Symbol indicates important messages in this manual.

alert to the possibility of personal injury.

Read this manual completely. This machine can amputate hands, feet, and throw objects. Failure to observe the following safety instructions could result in serious injury or death.

WARNING:

to cause cancer, birth defects or other reproductive harm.

The engine exhaust from this product contains chemicals known to the state of California

DANGER: Your log splitter was built to be operated according to the rules for safe operation in this

manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. If you violate any of these rules, you may cause serious injury to yourself or others.

• Read and understand the manual. Learn to operate this equipment in a safe manner. Familiarize

yourself with all of the controls in a safe environment before starting to work with this machine.

• DO NOT under any circumstances alter this log splitter. This equipment was designed and

engineered in accordance with operating instructions. Altering this equipment, or using this equipment in such a way as to circumvent its design capabilities and capacities, could result in serious injury or fatality and WILL VOID THE WARRANTY.

• Allow ONLY responsible adults who have read this manual to operate this machine. NEVER

allow children to operate this machine.

• NEVER operate or allow someone to operate this equipment while under the influence of

alcohol, drugs or medication. Being coherent is essential for safety.

• ALWAYS use outdoors with adequate ventilation. DON’T run the engine in an enclosed area.

Exhaust gases contain carbon monoxide. This odorless gas can be deadly when inhaled.

• NEVER use splitter for any other purpose than splitting wood. Any other use can result in

injury. Your splitter is a precision piece of power equipment, not a toy. Therefore, exercise extreme caution at all times.

•

ONLY a single operator is to load and operate the log splitter. KEEP all others, including pets and children, a minimum of 20 feet away from your work area. More accidents occur when more than one person operates the log splitter than any other time.

• ALWAYS wear protective gear such as safety goggles, protective hearing device, steel-toed

shoes, and tight-fitting gloves without drawstrings or loose cuffs.

• NEVER wear loose clothing or jewelry that can be caught by moving parts of the splitter and

pull you into it. Keep hair away from moving parts.

• NEVER operate your splitter on wet, muddy, or icy surfaces. KEEP work area clean of split

wood. Safe footing is essential in preventing accidents.

ONLY operate splitter on level ground with wheels blocked, not on the side of a hill. It could

•

tip, or rolling logs, poor footing, etc. could cause an accident.

•

NEVER operate your splitter near a flame or spark. Hydraulic oil and gasoline are flammable and can explode.

• NEVER fill gas tank while the engine is hot or running. Allow the engine to cool before refueling.

• This unit is equipped with an internal combustion engine and should not be used on or near any

unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used it should be maintained in effective working order by the operator.

-NOTE-

In the state of California, the above is required by law (Section 442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester muffler (optional by manufacturer) is available at your nearest engine dealer. Check legal requirements in your area.

• ONLY use your hands to operate the control lever. NEVER use foot, knee, rope or any extension device.

• Split ONLY one log at a time. NEVER attempt to split two logs on top of each other.

• NEVER place hands or feet between log and splitting wedge or between log and ram during forward or

reverse stroke. ALWAYS keep fingers clear of splits that open in log during splitting operation.

• DO NOT straddle or reach across the splitting area while operating the splitter.

• DO NOT step over splitter when the engine is running. You may trip or accidentally activate the splitting

wedge. Walk around to get to the other side.

• NEVER attempt to load splitter while splitting wedge is in motion. When loading log splitter, place hands

on the sides of the log, not the ends.

• NEVER attempt to split woods across the grain. Wood may burst or fly out of your splitter and result in

serious injury.

• NEVER leave your splitter unattended with the engine running. Shut off the engine if you are leaving

your splitter, even for a short period of time. Someone could accidentally activate the ram and be injured.

• Both ends of the log should be cut as squarely as possible to prevent the log from sliding out of the splitter

during operation. Log length should be kept to 24” or less.

• NEVER operate your splitter while it is attached to the tow vehicle.

• BEFORE towing, be certain that the splitter is securely attached to the towing vehicle and that the support

leg, beam and cylinder are secured in there respective towing positions.

• NEVER allow persons to ride on splitter. DO NOT carry any cargo or wood on your splitter. It may fall

off and cause an accident.

• DO NOT loosen or remove any hydraulic fitting, line or reservoir cap while your splitter or engine is

running.

• Fluid escaping from a very small hole can almost be invisible. DO NOT check for leaks with your hand.

See maintenance section for instructions. IF injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately.

• DO NOT operate your splitter in poor mechanical condition or when it is need of repair.

• ALWAYS disconnect the spark plug wire and place the wire where it cannot contact the spark plug, to

prevent accidental starting the engine when setting up, transporting, adjusting or repairing.

TOWING SAFETY

• Do not allow persons to ride on splitter. Do not carry any cargo or wood on your

splitter. It may fall off and endanger vehicles that are following you.

• Be sure support leg is in the travel position and coupling secure. This must also be

retracted so not to interfere while towing. Retract support leg by removing pin, pivoting up, and replacing pin.

• Never exceed 45 MPH while towing your splitter. Be extra cautious when traveling

over rough terrain, especially over railroad tracks.

• Always be careful while backing your splitter. You could jackknife your log splitter

if not careful.

• Before using splitter, disconnect it from tow vehicle. A log could easily be pushed

forward into the vehicle.

• See tire and wheel specifications for PSI while towing.

• Be aware of the extra length of splitter while turning, parking, crossing intersections,

and in all driving situations.

ADJUST COUPLER LOCKING PRESSURE ON BALL BEFORE USE. PLACE HANDLE IN LOCKED POSITION WITH BALL IN COUPLER. TIGHTEN LOCKNUT AGAINST TENSION SPRING SO THAT COUPLER IS NOT LOOSE ON BALL. CORRECT ADJUSTMENT WILL ALLOW HANDLE TO BE RELEASED WITH MODERATE PRESSURE APPLIED TO HANDLE.

OPERATION INSTRUCTIONS

POSI-LOCK COUPLER

TO OPEN, PULL UP ON COUPLER HANDLE AND ROTATE FORWARD. PLACE COUPLER ON BALL WHEN BALL IS COMPLETELY NESTED IN BALL SOCKET, ROTATE COUPLER HANDLE BACKWARD UNTIL HANDLE IS IN LOCKED POSITION.

AFTER TOWING FOR 50 MILES, CHECK COUPLER FOR TIGHTNESS ON BALL. ALWAYS CHECK TIGHTNESS BEFORE TOWING. BE SURE COUPLER HANDLE IS IN LOCKED POSITION.

WARNING: NEVER EXCEED WEIGHT CAPACITY AND ALWAYS USE SAFETY CHAINS. ALWAYS USE CORRECT BALL SIZE, MAKING SURE BALL IS COMPLETELY INSERTED INTO COUPLER. LOCK COUPLER HANDLE SECURELY BEFORE TOWING. ALWAYS CHECK FOR DAMAGES AND REPLACE IF DAMAGED. AVOID SHARP TURNS AND STEEP VERTICAL ANGLES WHEN TOWING.

ASSEMBLY

and constant speed indicating that all air has been expelled, shut the system off and refill the reservoir until the fluid is

See separate Engine Manual for fuel and oil recommendations. If applicable your log splitter has come equipped with

This log splitter has been partially assembled at the factory. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or replacement of parts.

Inspect all components for damage. If you believe you have a damaged part please contact customer service immediately at 1-800-222-8183.

WARNING: Exercise extreme caution, as parts are very heavy. Sufficient persons or mechanical handling

equipment should be used. Refer to uncrating and assembly instructions for assembly procedures.

OPERATION

INTENDED USE: This log splitter is intended and designed to only split wood. NEVER use for any other

purposes. Doing so can cause injury or VOID THE WARRANTY.

IMPORTANT: This unit is shipped with oil but without gasoline in the engine. After assembly, see separate

Engine Manual for proper fuel and oil recommendations.

WARNING: DO NOT START OR RUN THE LOG SPLITTER WITHOUT OIL IN THE ENGINE AND HYDRAULIC RESERVOIR.

FILLING THE HYDRAULIC RESERVOIR

Fill the hydraulic reservoir to the top mark on the dipstick or, depending on your Log Splitter model, to the lower fill line of the reservoir with Dexron III / Mercon automatic transmission fluid, 10W AW hydraulic fluid or Pro-Mix AW-32 Hydraulic oil. After the hydraulic reservoir and the engine crankcase are filled correctly with their respective oils, start the engine. Remember to set the throttle and turn on the fuel shut-off valve. The hydraulic pump should prime itself. With the engine running, move the hydraulic valve lever toward the wedge. This will cause the cylinder to extend and expel air. When the cylinder is fully extended, retract it. Repeat this procedure several times. (An erratic movement of the cylinder and wedge indicates that there is air in the system). Once the cylinder has a smooth

in the safe operating range as specified by the marks on the dipstick.

START UP WARNING: DO NOT START OR RUN THE LOG SPLITTER WITHOUT OIL IN THE ENGINE

AND HYDRAULIC RESERVOIR.

a fuel shut-off valve for towing purposes. Before starting engine make sure crankcase is filled correctly with oil and the proper fuel has been used. The engine will only start when the throttle lever and fuel shut-off valve if applicable are turned to their ON positions.

STARTING INSTRUCTIONS

1. Move throttle control to “FAST.”

2. Set Choke to “ON” position. NOTE: Do not use primer to restart a warm engine after a short shutdown.

3. Flip the engine control switch to “ON” position.

4. Grasp rope handle and pull out slowly until resistance it felt. Then pull rapidly with a full arm stroke. NOTE: If engine fails to start after three (3) pulls, repeat steps 1 and 2.

5. When Engine starts, set choke to “OFF” position and leave throttle control at “FAST.” The throttle must be

set in the fast position for maximum performance.

6. To stop engine, move throttle lever to “SLOW” for a few seconds then flip the engine control switch to

“OFF” position.

IMPORTANT: This engine is not equipped with a spark arrester muffler. It is a violation of California Public Resource Code Section 4442 to use or operate the engine on any forest-covered, brush-covered, or grass-covered land. Other states or federal areas may have similar laws.

+ 14 hidden pages