Manufacturing quality lawn care equipment since 1945
Safety
Assembly
Operation
Service and Adjustment
Repair Parts
FAX 660-747-8650
Made In The
USA
LIMITED WARRANTY
The manufacturer’s warranty to the original consumer purchaser is: This product is free from defects in
materials and workmanship for the period's shown below beginning from the date of purchase by the original
consumer purchaser. We will repair or replace, at our discretion, parts found to be defective due to materials or
workmanship. This warranty is subject to the following limitations and exclusions:
Engine WarrantyAll engines utilized on our products have a separate warranty extended
to them by the individual engine manufacturer. Any engine service
difficulty is the responsibility of the engine manufacturer and in no
way is Swisher or its agents responsible for the engine warranty. Engine
warranty and contact information is as shown in the engine owners
manual.
Hydraulic System1 Year
Steel Components3 Years
Commercial UseThe warranty period for this product when used for commercial or rental
is limited to ninety (90) days from the date of original purchase.
LimitationThis warranty applies only to products which have been properly
assembled, adjusted, and operated in accordance with the instructions
contained within this manual. This warranty does not apply to any
product of Swisher that has been subject to alteration, misuse, abuse,
improper assembly or installation, shipping damage or to normal wear of
product.
ExclusionsExcluded from this warranty are normal wear items, normal or routine
adjustments, and normal or routine maintenance.
In the event you have a claim under this warranty, you must return the product to an authorized service dealer.
All transportation charges, damage, or loss incurred during transportation of parts submitted for replacement or
repair under this warranty shall be borne by the purchaser. Should you have any questions concerning this
warranty, please contact us toll-free at 1-800-222-8183. The model number, serial number, date of purchase,
and the name of the authorized Swisher dealer from whom you purchased the splitter will be needed before any
warranty claim can be processed.
THIS WARRANTY DOES NOT APPLY TO ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGES AND ANY IMPLIED WARRANTIES ARE LIMITED TO THE SAME TIME PERIODS
STATED HEREIN FOR ALL EXPRESSED WARRANTIES. Some states do not allow the limitation of
consequential damages or limitations on how long an implied warranty may last, so the above limitations or
exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights,
which vary from state-to-state. This is a limited warranty as defined by the Magnuson-Moss Act of 1975.
MAINTENANCE.…………………….8
DECALS…..………….……………….9
PARTS BREAKDOWN………………10-14
SPECIFICATIONS..………………….17
2
Your splitter is a precision piece of power equipment, not a toy. Therefore, exercise extreme caution at
shoes, and
This Safety Alert Symbol indicates important messages in t
his manual.
SAFETY PRECAUTIONS
When you see this symbol, carefully read the message that follows and be
alert to the possibility of personal injury.
Read this manual completely. This machine can amputate hands, feet, and throw objects.
Failure to observe the following safety instructions could result in serious injury or death.
WARNING:
cause cancer, birth defects or other reproductive harm.
The engine exhaust from this product contains chemicals known to the state of California to
DANGER:Your log splitter was built to be operated according to the rules for safe operation in this manual.
As with any type of power equipment, carelessness or error on the part of the operator can result in serious
injury. If you violate any of these rules, you may cause serious injury to yourself or others.
•Read and understand the manual. Learn to operate this equipment in a safe manner. Familiarize
yourself with all of the controls in a safe environment before starting to work with this machine.
•DO NOT under any circumstances alter this log splitter. This equipment was designed and engineered
in accordance with operating instructions. Altering this equipment, or using this equipment in such a
way as to circumvent its design capabilities and capacities, could result in serious injury or fatality and
WILL VOID THE WARRANTY.
•Allow ONLY responsible adults who have read this manual to operate this machine. NEVER allow
children to operate this machine.
•NEVER operate or allow someone to operate this equipment while under the influence of alcohol,
drugs or medication. Being coherent is essential for safety.
•ALWAYS use outdoors with adequate ventilation. DON’T run the engine in an enclosed area.
Exhaust gases contain carbon monoxide. This odorless gas can be deadly when inhaled.
•NEVER use splitter for any other purpose than splitting wood. Any other use can result in injury.
all times.
•ONLY a single operator is to load and operate the log splitter. KEEP all others, including pets and
children, a minimum of 20 feet away from your work area. More accidents occur when more than one
person operates the log splitter than any other time.
•ALWAYS wear protective gear such as safety goggles, protective hearing device, steel-toed
tight-fitting gloves without drawstrings or loose cuffs.
•NEVER wear loose clothing or jewelry that can be caught by moving parts of the splitter and pull you
into it. Keep hair away from moving parts.
•NEVER operate your splitter on wet, muddy, or icy surfaces. KEEP work area clean of split wood.
Safe footing is essential in preventing accidents.
• ONLY operate splitter on level ground with wheels blocked, not on the side of a hill. It could tip, or
rolling logs, poor footing, etc. could cause an accident.
3
•
In the state of California, the above is required by law (Section 442 of the California Public Resources Code).
DO NOT step over splitter when the engine is running. You may trip or accidentally activate the splitting
itter is securely attached to the towing vehicle and that the support
SAFETY PRECAUTIONS
NEVER operate your splitter near a flame or spark. Hydraulic oil and gasoline are flammable and can
explode.
• NEVER fill gas tank while the engine is hot or running. Allow the engine to cool before refueling.
• This unit is equipped with an internal combustion engine and should not be used on or near any
unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is
equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used it
should be maintained in effective working order by the operator.
-NOTE-
Other states may have similar laws. Federal laws apply on federal lands. A spark arrester muffler (optional
by manufacturer) is available at your nearest engine dealer. Check legal requirements in your area.
• ONLY use your hands to operate the control lever. NEVER use foot, knee, rope or any extension device.
• Split ONLY one log at a time. NEVER attempt to split two logs on top of each other.
• NEVER place hands or feet between log and splitting wedge or between log and ram during forward or
reverse stroke. ALWAYS keep fingers clear of splits that open in log during splitting operation.
• DO NOT straddle or reach across the splitting area while operating the splitter.
•
wedge. Walk around to get to the other side.
•NEVER attempt to load splitter while splitting wedge is in motion. When loading log splitter, place
hands on the sides of the log, not the ends.
•NEVER attempt to split woods across the grain. Wood may burst or fly out of your splitter and result in
serious injury.
•NEVER leave your splitter unattended with the engine running. Shut off the engine if you are leaving
your splitter, even for a short period of time. Someone could accidentally activate the ram and be injured.
•Both ends of the log should be cut as squarely as possible to prevent the log from sliding out of the
splitter during operation. Log length should be kept to 25 1/2” or less.
• NEVER operate your splitter while it is attached to the tow vehicle.
• BEFORE towing, be certain that the spl
leg, beam and cylinder are secured in there respective towing positions.
•NEVER allow persons to ride on splitter. DO NOT carry any cargo or wood on your splitter. It may fall
off and cause an accident.
•DO NOT loosen or remove any hydraulic fitting, line or reservoir cap while your splitter or engine is
running.
•Fluid escaping from a very small hole can almost be invisible. DO NOT check for leaks with your hand.
See maintenance section for instructions. IF injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately.
• DO NOT operate your splitter in poor mechanical condition or when it is need of repair.
• ALWAYS disconnect the spark plug wire and place the wire where it cannot contact the spark plug, to
prevent accidental starting the engine when setting up, transporting, adjusting or repairing.
4
•
TIGHTNESS BEFORE TOWING. BE SURE COUPLER HANDLE IS IN LOCKED POSITION.
TOWING SAFETY
Do not allow persons to ride on splitter. Do not carry any cargo or wood on your
splitter. It may fall off and endanger vehicles that are following you.
• Be sure support leg is in the travel position and coupling secure. This must also be
retracted so not to interfere while towing. Retract support leg by removing pin,
pivoting up, and replacing pin.
• Never exceed 45 MPH while towing your splitter. Be extra cautious when traveling
over rough terrain, especially over railroad tracks.
• Always be careful while backing your splitter. You could jackknife your log splitter
if not careful.
• Before using splitter, disconnect it from tow vehicle. A log could easily be pushed
forward into the vehicle.
• See tire and wheel specifications for PSI while towing.
• Be aware of the extra length of splitter while turning, parking, crossing intersections,
and in all driving situations.
•
ADJUST COUPLER LOCKING PRESSURE ON BALL BEFORE USE. PLACE HANDLE IN LOCKED
POSITION WITH BALL IN COUPLER. TIGHTEN LOCKNUT AGAINST TENSION SPRING SO THAT
COUPLER IS NOT LOOSE ON BALL. CORRECT ADJUSTMENT WILL ALLOW HANDLE TO BE
RELEASED WITH MODERATE PRESSURE APPLIED TO HANDLE.
TO OPEN, PULL UP ON COUPLER HANDLE AND ROTATE FORWARD. PLACE COUPLER ON BALL
WHEN BALL IS COMPLETELY NESTED IN BALL SOCKET, ROTATE COUPLER HANDLE
BACKWARD UNTIL HANDLE IS IN LOCKED POSITION.
AFTER TOWING FOR 50 MILES, CHECK COUPLER FOR TIGHTNESS ON BALL. ALWAYS CHECK
OPERATION INSTRUCTIONS
POSI-LOCK COUPLER
WARNING:
NEVER EXCEED WEIGHT CAPACITY AND ALWAYS USE SAFETY CHAINS. ALWAYS USE
CORRECT BALL SIZE, MAKING SURE BALL IS COMPLETELY INSERTED INTO COUPLER. LOCK
COUPLER HANDLE SECURELY BEFORE TOWING. ALWAYS CHECK FOR DAMAGES AND
REPLACE IF DAMAGED. AVOID SHARP TURNS AND STEEP VERTICAL ANGLES WHEN TOWING.
5
This log splitter has been most
ly assembled at the factory.
Refer to uncrating and assembly instructions to complete the
RESERVOIR.
HYDRAULIC RESERVOIR.
ASSEMBLY
final assembly step. Refer to the drawings and part lists should it become necessary to disassemble the unit for repair or
replacement of parts.
Inspect all components for damage. If you believe you have a damaged part please contact customer service immediately
at 1-800-222-8183.
WARNING: Exercise extreme caution, as parts are very heavy. Sufficient persons or mechanical handling equipment
should be used.
OPERATION
INTENDED USE: This log splitter is intended and designed to only split wood. NEVER use for any other purposes.
Doing so can cause injury or VOID THE WARRANTY.
IMPORTANT: This unit is shipped with oil but without gasoline in the engine. After assembly, see separate Engine
Manual for proper fuel and oil recommendations.
WARNING: DO NOT START OR RUN THE LOG SPLITTER WITHOUT OIL IN THE ENGINE AND/OR HYDRAULIC
FILLING THE HYDRAULIC RESERVOIR
Fill the hydraulic reservoir to within the hydraulic operating range as marked on dipstick supplied on the hardware bag
with general-purpose automatic transmission fluid or general-purpose hydraulic fluid. After the hydraulic reservoir and
the engine crankcase are filled correctly with their respective oils, start the engine. Remember to set the throttle and turn
on the fuel shut-off valve. The hydraulic pump should prime itself. With the engine running, move the hydraulic valve
lever toward the wedge. This will cause the cylinder to extend and expel air. When the cylinder is fully extended, retract
it. Repeat this procedure several times. (An erratic movement of the cylinder indicates that there is air in the system).
Once the cylinder has a smooth and constant speed indicating that all air has been expelled, add fluid until the level is
within the indicated range as marked on the dipstick.
START UP
WARNING: DO NOT START OR RUN THE LOG SPLITTER WITHOUT OIL IN THE ENGINE AND/OR
See separate Engine Manual for fuel and oil recommendations. If applicable your log splitter has come equipped with a
fuel shut-off valve for towing purposes.
Before starting engine make sure crankcase is filled correctly with oil and the proper fuel has been used. The engine will
only start when the throttle lever and fuel shut-off valve if applicable are turned to their ON positions.
STARTING INSTRUCTIONS
See Engine Manual
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.