SwimPro SWP120551, SWP121051, SWP120751, SWP121551, SWP1205 Installation & Operating Instructions Manual

SWIMMING POOL PUMP

INSTALLATION & OPERATING INSTRUCTIONS

WARNING: Read and follow all instructions in this manual and on the equipment. Failure to follow instructions can cause

serious injury or death.

WARNING: Electrical Hazard. Failure to follow Instructions can result in serious injury.

WARNING: Appropriately qualified and licensed personnel should install the pump and carry out the electrical connections.

WARNING: All electrical connections must be done by a qualified electrician according to local electrical standards.

WARNING: Pump should be wired to the main supply through an approved and correctly rated contactor and GFCI.

WARNING: Children and persons with reduced physical, sensory or mental capabilities, or lack of experience should not handle

and operate the pump. Fingers and foreign objects should be kept away from the openings and moving parts.

WARNING: Motor must be suitably grounded.

WARNING: The motor must be connected with other bonded parts using appropriately sized conductor using the bonding lug.

WARNING: Power supply voltage required by motor should correspond to that of the network and correctly sized cables

should be used to connect the pump motor.

WARNING: Disconnect the pump from the main power supply completely before servicing.

WARNING: Ensure that the appropriate precautions have been taken to prevent suction entrapment. A minimum of two

correctly sized suction points are required for each pump.

WARNING: Never run the pump dry! Running the pump dry damages the seals and bearings and can cause leakage and

flooding.

WARNING: Do not try to open the lid or service the pump while it is in operation.

WARNING: Do not use petroleum based lubrication for the plastic and rubber components as they will damage the
components and lead to failure.

WARRANTY

To the original purchasers of this equipment, this product is warranted to be free from defects in materials and workmanship.

The product is warrantied for a period of ONE year from the date of purchase. Seals, baskets and o-rings are warranted for

defects in material and workmanship for a period of 30 days.

Improper installation, use, care, negligence and any damage or defect as a result of freezing, flood, fire, accident, lightin g shall

not be covered by the warranty.

The defective product must be returned to the authorized dealer. The cost of returning the product to the dealer and any

consequential costs and damages are not covered by the warranty.

Product Registration

DATE OF INSTALLATION:___________________________________

PURCHASED FROM: __________________________________________________________________________

MODEL: ____________________________________ SERIAL NUMBER:_________________________________

INSTALLATION

Install the pump at the right distance from the base to minimize the distance between the suction point and pump.

Install the pump in a ventilated and dry place. The motor requires air to flow freely around it.

Install the pump so that the external disconnect switch is easily visible and accessible and located close to the pump.

Install a proper ground connection

Fit a 30mA GFCI in the circuit.

Ensure that the power supply voltage matches the voltage on the motor.

Replace all covers before operation.

OPERATION

If the pump is in a flooded suction installation the pump will prime itself when the suction and discharge valves are open.

If the pump is installed above the water level the pump needs to be properly primed prior to start up.

Open the strainer cover and fill strainer housing with water to suction pipe level.

Check the gasket on the cover and replace the strainer cover and secure.

Open all suction and discharge valves as well as air bleed on filter.

Turn on power and allow a reasonable time for priming.

If pump does not start see Troubleshooting Guide.

MAINTENANCE

Clean the strainer basket regularly. Inspect the strainer cover and strainer basket for any damage. Replace as necessary.

The pumps have self-lubricating motor bearings and shaft seals. No lubrication is necessary.

Keep motor clean. Insure air vents are free from obstruction.

Depending on the operating conditions the seals will need replacement as they wear over time.

Please contact your local agent or dealer for any repair, maintenance and spare parts. Provide the pump and motor details.