Swimline 55000 User Manual Page 1
3 INCH RANGE POLE SET ASSEMBLY:
• Loosely assemble extruded tubes together. Slide excess width into adjoining tubes, dividing it up as equally as possible.
Note: You must have a minimum of 9” of overlap in each tube!
• Measure the width across the pool from plug surface to plug surface & adjust length of the tube assembly to fit the span.
• Lock the tubes together by rotating each adjoining tube in the opposite direction. (See Figure C)
• Secure each tube with just 1 self drilling screw in each adjoining tube.
• Attach the tube assembly into the Crank and Tubing Plugs and check for fit. Assemble Tube assembly together with
Crank Handles and Tube Plugs by lining up hole in the end of each tube fitted into Crank Handle and secure with metal
Axle Bolt and nut provided.
• When all is OK drill and screw the remaining screws at each end of the overlapped poles. You should have 6 screws on
each tube end where there is a connection.
3 INCH RANGE
POLE SET
ASSEMBLY:
Measure Plug Surface To Plug Surface
Minimum
9"
Overlap
Use Large Plug
For Pole Kit 5116
Only!
Item #55000 Instructions
Fig. C
Twist
Tubing To
Remove
Excess
Play Prior
To Screwing
Together.
Fasten
With
Axle
Bolt
Fasten with
6 screws at each join
in pre-drilled holes
Fasten with
6 screws at each join
in pre-drilled holes
Fasten
With
Axle
Bolt
Measure Plug Surface To Plug Surface
4&5 INCH RANGE
POLE SET
ASSEMBLY:
Fasten
With
Axle
Bolt
4&5 INCH RANGE POLE SET ASSEMBLY:
• Follow instructions as above except...
• When all is OK drill through holes in large outer tubes using pre-drilled holes as a template. Drill from each side with
Drill Bit supplied.
• Fasten with 2 Bolts & Nuts at each join. Bolts are at right angles to each other
2 Bolts at each join
(pre-drilled in outer tube)
Minimum
Overlap
Fasten with
9"
Fasten with
2 Bolts at each join
(pre-drilled in outer tube)
Fasten
With
Axle
Bolt
Commercial Reel System
For In Ground Solar Pool Covers
12” Fixed Height
9. Attach Straps to Tubes:
Come in 6 inches from each tube end and attach a strap plate to the aluminum tube assembly. Use the self drilling screws
on the drill line to attach the plate. Look at the holes that were pre-drilled at the factory and use the same drill line. There
are 6 lines on each tube. Take the remaining strap plates and connect them evenly along the length of the tube assembly.
Attach Straps to strap plate. (See Figure D)
10. Attach Solar Blanket to Straps:
If Wheel is to be placed at the end of the pool, attach cover to strap plate with plastic screw as shown in Figure
Below Left. If Wheel is to be placed in offset position, then attach cover to strap plate forming a fold to act like a hinge and
the plastic screw will go through two layers of the solar blanket as shown in Figure F Below Right.
Bubbles should face down.
Plastic Screw
Plastic Screw
Solar Blanket
Strap & Bracket
Solar Blanket Folded
Strap & Bracket
Fig. E Fig. F
Fig. D
Thread
Strap
as Shown
Loading...